Инструкция по эксплуатации Yamaha RX-V365 — страница 20

BASIC OPERATION

Turn on external components (TV DVD player etc.) connected to this unit.

Press CSPEAKERS repeatedly to select the front speakers you want to use The respective speaker indicators lights up on the front panel display.

Press NINPUT l h repeatedly (or press one of the input selector buttons (e)) to select the desired input source The name of the currently selected input source appears on the front panel display for a few seconds.

Start playback on the selected component or select a broadcast station.

Notes

• Refer to the operating instructions for the source component.

- See page 27 for details about FM or AM tuning instructions.

• To adjust the level of each speaker see page 20.

Rotate PVOLUME (or press gVOLUME +/–)
to adjust the volume to the desired output level.

• See page 20 to adjust the level of each speaker.

- This does not affect the AUDIO OUT (REC) level.

- You can set the initial volume level and maximum volume level (see page 34).

Press LPROGRAM l h (or press uPROG l h) repeatedly to select the desired sound field program The name of the selected sound field program appears on the front panel display See page 22 for details about sound field programs.

Notes

• Choose a sound field program based on your listening preference not merely on the name of the program.

• When you select an input source this unit automatically selects the last sound field program used with the corresponding input source.

• Sound field programs cannot be selected when the component connected to the MULTI CH INPUT jacks is selected as the input source (see page 19).

• When PCM signals with a sampling frequency higher than 48 kHz are input this unit is automatically set to the “STRAIGHT” mode (see page 26).

• To display information about the currently selected input source on the front panel display see page 21 for details.

Playback

Caution Extreme caution should be exercised when you play back CDs encoded in DTS If you play back a CD encoded in DTS on a DTS-incompatible CD player you will only hear some unwanted noise that may damage your speakers Check whether your CD player supports CDs encoded in DTS Also check the sound output level of your CD player before you play back a CD encoded in DTS.

Basic procedure

INPUT: DVD

V-AUX

DTV/CBL

MD/CD-R

TUNER

Available input source

Currently selected input source

M o v i e D r a m a t i c

Currently selected surround field program