Инструкция по эксплуатации Yamaha RX-V365 — страница 18

This unit has the Yamaha Parametric Acoustic Optimizer (YPAO) With the YPAO this unit automatically adjusts output characteristics of your speakers based on speaker positions speaker performances and acoustic characteristics of the room We recommend that you first adjust the output characteristics with the YPAO when you use this unit.

• Initial settings are indicated by (*) in the following each parameter.

Make sure of the following check points Before starting the automatic setup check the following check points.

- All speakers and subwoofer are connected appropriately.

• Headphones are disconnected from this unit.

- This unit is turned on.

- The connected subwoofer is tuned on and the volume level is set to about half way (or slightly less).

• FRONT A speakers are selected as the front speaker system (see page 19).

• The room is sufficiently quiet.

- The crossover frequency control of the connected subwoofer is set to the maximum.

Connect the supplied optimizer microphone to the OPTIMIZER MIC jack on the front panel. “SETUP•••••AUTO” appears on the front panel display.

Place the optimizer microphone at your normal listening position on a flat level surface with the omni-directional microphone heading upward.

• We recommend that you use a tripod (etc.) to affix the optimizer microphone at the same height as your ears would be when you are seated in your listening position You can use the attached screw of a tripod (etc.) to fix the optimizer microphone to the tripod (etc.).

Press ol h to select “AUTO.”

Note

• “RELOAD” or “UNDO” is available only when you have previously run “AUTO SETUP” and confirmed the results.

Press oENTER to start the setup procedure This unit starts the automatic setup procedure Loud test tones are output from each speaker during the audio setup procedure After all settings (“INITIALIZING,” “WIRING/LEVEL,”
“DISTANCE,” “SIZE”) are sequentially completed “FINISH” appears on the front panel display.

• To cancel the automatic setup press ok.

Optimizing the speaker setting for your listening room (YPAO)

Notes • Be advised that it is normal for loud test tones to be output during the “AUTO SETUP” procedure Do not allow small children to enter the room during the procedure.

• To achieve the best results make sure that the room is as quiet as possible while the “AUTO SETUP”
procedure is in progress If there is too much ambient noise the results may not be satisfactory.

Using AUTO SETUP

VOLUME

CROSSOVER

HIGH CUT

Controls of a subwoofer (example)

Choice

Function

AUTO*

Automatically runs the entire “AUTO

SETUP” procedure.

RELOAD

Reloads the last “AUTO SETUP” settings and overrides the previous settings.

UNDO

Undoes the last “AUTO SETUP” settings and restores the previous settings.

DEFAULT

Resets the “AUTO SETUP” parameters to the initial factory settings.

Optimizer microphone