Инструкция по эксплуатации Yamaha RX-V365 — страница 19

Optimizing the speaker setting for your listening room (YPAO)

English

INTR

ODUCTION

DITIONAL

INFORMA

APPENDIX

OPERA

ANCED

OPERA

Notes

• During the automatic setup procedure do not perform any operation on this unit.

• We recommend that you get out of the room while this unit is in the auto setup procedure It takes approximately 3 minutes for this unit to complete the auto setup procedure.

When all measurements are completed successfully “FINISH” appears on the front panel display The result of the automatic setup for each speaker appears in order on the front panel display.

• To display the result of the automatic setup again press lk n repeatedly.

Notes

• If you select “RELOAD” in step 4 no test tones are output.

- If an error occurs during the “AUTO:CHECK” procedure the setup procedure is canceled and an error screen appears For details see “If an error screen appears” on page 17.

• When this unit detects potential problems during the “AUTO

SETUP” procedure “WARNING” and the warning messages appear after this unit displays the result of the automatic setup For details refer to the “AUTO SETUP” section in “Troubleshooting”
on page 41.

• The distance measurement result may be longer than the actual distance depending on the characteristics of your subwoofer.

Press ol h to select “SET” or “CANCEL.”

Press oENTER to confirm your selection. “AUTO SETUP” appears on the front panel display.

Press kMENU to exit from “SET MENU.”

Disconnect the optimizer microphone from this unit The optimizer microphone is sensitive to heat Keep it away from direct sunlight and do not place it on top of this unit.

• If you change speakers speaker positions or the layout of your listening environment run “AUTO SETUP” again to recalibrate your system.

• When you want to check the result of the automatic setup in detail or manually adjust the parameters use “MANUAL SETUP” (see page 32).

■ If an error screen appears If this unit detects the potential problems an error message appears on the front panel display during the automatic setup For details about each error message see the “AUTO SETUP” section in “Troubleshooting” on page 41. After a few seconds later the following choices appear Press ol h to select “RETRY” or “EXIT” and then press oENTER.

■ If “WARNING” appears When this unit detects potential problems during the automatic setup procedure “WARNING” appears on the front panel display after result of each speaker Check the warning messages to correct your speaker settings.

Note

• Warnings differ from errors in that warnings do not cancel the automatic setup procedure.

Press on to display the detailed information about the warning The detailed information about the warning is displayed and the indicators of inapplicable speakers blink on the front panel display.

• For details about each warning message see the “AUTO SETUP” section in “Troubleshooting” on page 41.

Choice

Function

SET*

Confirms the “AUTO SETUP” results.

CANCEL

Cancels the “AUTO SETUP” results.

FL: 3.3m

The distance between the speaker and the listening position

The result of the adjustment of the volume level

Speaker

FL/FR: Front left/right

C: Center

SL/SR: Surround left/right

SW: Subwoofer

Choice

Function

RETRY*

Starts the “AUTO SETUP” again.

EXIT

Exits from the “AUTO SETUP” procedure.

PHASE REVERSED

Flashes