Инструкция по эксплуатации Yamaha RX-V365 — страница 17

Connections

English

INTR

ODUCTION

DITIONAL

INFORMA

APPENDIX

OPERA

ANCED

OPERA

Both FM and AM indoor antennas are supplied with this unit In general these antennas should provide sufficient signal strength Connect each antenna correctly to the designated terminals.

Notes

• The AM loop antenna should be placed away from this unit.

- A properly installed outdoor antenna provides clearer reception than an indoor one If you experience poor reception quality install an outdoor antenna Consult the nearest authorized Yamaha dealer or service center about outdoor antennas.

• The AM loop antenna should always be connected even if an outdoor

AM antenna is connected to this unit.

Connecting the wire of the AM loop antenna

Assembling the supplied AM loop antenna

Note

• The types of the supplied AM loop antenna is different depending on the models.

Once all connections are complete plug the power cable into the AC wall outlet.

Press ASTANDBY/ON (or cPOWER) to turn on this unit.

• When you turn on this unit there will be a 4 to 5-second delay before this unit can reproduce sound.

Press ASTANDBY/ON (or bSTANDBY) to turn off this unit.

Note

• In the standby mode this unit consumes a small amount of power in order to receive infrared signals from the remote control.

Connecting the FM and AM antennas

ANTENNA

R SURRO

AUDIO

OUTP

UNBAL.

MONITOR

CD-R

(REC)

(PLAY)

Outdoor AM antenna

Use a 5 to 10 m (16 to 32 ft)
of vinyl-covered wire extended outdoors from a window.

AM loop antenna (supplied)

Indoor FM antenna (supplied)

Ground

For maximum safety and minimum interference connect the antenna GND terminal to a good earth ground A good earth ground is a metal stake driven into moist earth.

Open the lever

Insert

Close the lever

Connecting the power cable

Turning on and off the power

Turning on this unit

Set this unit to the standby mode

Power cable

To the AC wall outlet