Инструкция по эксплуатации Generac GP6000E — страница 16

3.4.4 CHECKING OIL LEVEL

See the “Before Starting the Generator” section for information on checking the oil level The oil level should be checked before each use or at least every eight hours of operation Keep the oil level maintained.

3.4.5 CHANGING THE OIL

Change the oil after the first 20 to 30 hours of operation Change the oil every 50 to 100 hours or every season thereafter If running this unit under dirty or dusty conditions or in extremely hot weather change the oil more often.

Hot oil may cause burns Allow engine to cool before draining oil Avoid prolonged or repeated skin exposure with used oil

Thoroughly wash exposed areas with soap.

Use the following instructions to change the oil after the engine cools down:

1 Clean area around oil drain plug. 2 Remove oil drain plug from engine and oil fill plug to drain oil completely into a suitable container.

3 When oil has completely drained install oil drain plug and tighten securely.

4 Fill oil sump with recommended oil (See “Before Starting the

Generator” for oil recommendations).

5 Wipe up any spilled oil. 6 Dispose of used oil at a proper collection center.

3.4.6 REPLACING THE SPARK PLUG

See Engine Specifications for recommended spark plug Replace the plug once each year This will help the engine start easier and run better.

1 Stop the engine and pull the spark plug wire off of the spark plug.

2 Clean the area around the spark plug and remove it from the cylinder head.

3 Set the spark plug's gap to 0.70-0.80 mm Install the correctly gapped spark plug into the cylinder head (Figure 14).

Figure 14 Spark Plug Gap

3.4.7 BATTERY REPLACEMENT (IF APPLICABLE)

NOTE:

The battery shipped with the generator has been fully charged

A battery may lose some of its charge when not in use for prolonged periods of time If the battery is unable to crank the engine plug in the 12V charger included in the accessory box (see the Charging a Battery section) RUNNING THE GENERATOR

DOES NOT CHARGE THE BATTERY The part number for this battery is 0G9449.

The NEGATIVE battery terminal should:

1 Always be DISCONNECTED FIRST.

2 Always be CONNECTED LAST.

Figure 15 Battery Connections

3.4.8 SPARK ARRESTOR

The engine exhaust muffler has a spark arrestor screen Inspect and clean the screen at least once each year (Figure 16) If unit is used regularly inspect and clean more often.

NOTICE:

If using the generator on any forest-covered brush-covered or grass-covered unimproved land it must equipped with a spark arrestor The spark arrestor must be maintained in good condition by the owner/operator Clean and inspect the spark arrestor as follows:

1 Remove clamp and spark arrestor from muffler. 2 Inspect screen and replace if torn perforated or otherwise damaged DO NOT USE a defective screen If screen is not damaged clean it with commercial solvent.

3 Replace the spark arrestor and clamp.

Maintenance