Инструкция по эксплуатации Generac GP6000E — страница 14

Maintenance

2.11 CHARGING THE BATTERY (ELECTRIC START

UNITS ONLY)

Storage batteries give off explosive hydrogen gas while recharging An explosive mixture will remain around the battery for a long time after it has been charged The slightest spark can ignite the hydrogen and cause an explosion

Such an explosion can shatter the battery and cause blindness or other serious injury.

Do not permit smoking open flame sparks or any other source of heat around a battery Wear protective goggles rubber apron and rubber gloves when working around a battery Battery electrolyte fluid is an extremely corrosive sulfuric acid solution that can cause severe burns If spill occurs flush area with clear water immediately.

NOTE:

The battery shipped with the generator has been fully charged

A battery may lose some of its charge when not in use for prolonged periods of time If the battery is unable to crank the engine plug in the 12V charger included in the accessory box

RUNNING THE GENERATOR DOES NOT CHARGE THE BATTERY. Use battery charger plug to keep the battery charged and ready for use Battery charging should be done in a dry location.

1 Plug charger into “Battery Charger Input” jack located on the control panel (Figure 13) Plug wall receptacle end of the battery charger into a 230 Volt AC wall outlet.

2 Unplug battery charger from wall outlet and control panel jack when generator is going to be in use.

NOTE:

Do not use the battery charger for more than 48 hours at one charge.

Figure 13 Battery Charger Jack

BATTERY

CHARGER

INPUT

3.1 PERFORMING SCHEDULED MAINTENANCE

It is important to perform service as specified in the Maintenance

Schedule for proper generator operation and to ensure that the generator complies with the applicable emission standards for the duration of its useful life Service and repairs may be performed by any capable person or repair shop Additionally emissions critical maintenance must be performed as scheduled in order for the

Emissions Warranty to be valid Emissions critical maintenance consists of servicing the air filter and spark plugs in accordance with the Maintenance Schedule 3.2 MAINTENANCE SCHEDULE

3.2.1 GP5000/GP6000 MAINTENANCE SCHEDULE

Follow the calendar intervals More frequent service is required when operating in adverse conditions noted below Check Oil Level

At Each Use

Change Oil ‡

*Every 100 hours or Every Season

Check Valve Clearance

***Every Season

Service Air Filter

** Every 200 hours or Every Season

Replace Spark Plug

Every Season

‡ Change oil after first 30 hours of operation then every season. * Change oil and oil filter every month when operating under heavy load or in high temperatures.

** Clean more often under dirty or dusty operating conditions Replace air filter parts if they cannot be adequately cleaned.

*** Check valve clearance and adjust if necessary after first 50 hours of operation and every 100 hours thereafter.

3.2.2 GP2600 MAINTENANCE SCHEDULE

Follow the calendar intervals More frequent service is required when operating in adverse conditions noted below Check Oil Level

At Each Use

Change Oil ¥

*Every 50 Hours

Check Valve Clearance

***Every Season

Service Air Filter

**Every 25 Hours

Replace Spark Plug

****Every 100 Hours

¥ Change oil after first 20 hours of operation. *

Change oil every month when operating under heavy load or in high temperatures.

** Clean more often under dirty or dusty operating conditions Replace air filter parts if they cannot be adequately cleaned.

*** Check valve clearance and adjust if necessary after first 50 hours of operation and every 100 hours thereafter.

**** Clean and re-gap spark plug every 50 hours.