Инструкция по эксплуатации Generac GP6000E — страница 19

Troubleshooting

4.1 TROUBLESHOOTING GUIDE

PROBLEM

CAUSE

CORRECTION

Engine is running but no AC output is available.

1 Circuit breaker is open. 2 Poor connection or defective cord set. 3 Connected device is bad. 4 Fault in generator.

1 Reset circuit breaker. 2 Check and repair. 3 Connect another device that is in good condition. 4 Contact Authorized Service Facility.

Engine runs well but bogs down when loads are connected.

1 Short circuit in a connected load. 2 Generator is overloaded. 3 Engine speed is too slow. 4 Shorted generator circuit.

1 Disconnect shorted electrical load. 2 See “Don’t Overload the Generator”
3 Contact Authorized Service Facility. 4 Contact Authorized Service Facility.

Engine will not start; or starts and runs rough.

1 Fuel Shut-off is OFF. 2 Dirty air filter. 3 Out of gasoline. 4 Stale gasoline. 5 Spark plug wire not connected to spark plug. 6 Bad spark plug. 7 Water in gasoline. 8 Over-choking. 9 Low oil level. 10 Excessive rich fuel mixture. 11 Intake valve stuck open or closed. 12 Engine has lost compression.

1 Turn Fuel Shut-off to ON. 2 Clean or replace air filter. 3 Fill fuel tank. 4 Drain fuel tank and fill with fresh fuel. 5 Connect wire to spark plug. 6 Replace spark plug. 7 Drain fuel tank; fill with fresh fuel. 8 Put choke knob to No Choke position. 9 Fill crankcase to proper level. 10 Contact Authorized Service Facility. 11 Contact Authorized Service Facility. 12 Contact Authorized Service Facility.

Engine shuts down during operation.

1 Out of gasoline. 2 Low oil level. 3 Fault in engine.

1 Fill fuel tank. 2 Fill crankcase to proper level. 3 Contact Authorized Service Facility.

Engine lacks power.

1 Load is too high. 2 Dirty air filter. 3 Engine needs to be serviced.

1 Reduce load (see “Don’t Overload the Generator”). 2 Clean or replace air filter. 3 Contact Authorized Service Facility.

Engine “hunts” or falters.

1 Choke is opened too soon.

2 Carburetor is running too rich or too lean.

1 Move choke to halfway position until engine runs smoothly.

2 Contact Authorized Service Facility.