Инструкция по эксплуатации Generac GP6000E — страница 12

Any attempt to crank or start the engine before it has been properly serviced with the recommended oil may result in an engine failure.

1 Place generator on a level surface (not to exceed 15° in any direction).

2 Clean area around oil fill and remove oil fill cap. 3 Slowly fill engine with oil until the dipstick reads full Stop filling occasionally to check oil level.

4 Install dipstick and finger tighten securely. 5 Check engine oil level before starting each time thereafter.

2.6.2 ADDING GASOLINE

NEVER fill fuel tank indoors Avoid spilling gasoline on hot engine Allow engine to cool entirely before adding fuel NEVER fill fuel tank when engine is running or hot DO NOT light a cigarette or smoke when filling the fuel tank

Gasoline is highly flammable and its vapors are

EXPLOSIVE.

Do not overfill the fuel tank Always leave room for fuel expansion If the fuel tank is overfilled fuel can over flow onto a hot engine and cause fire or an explosion Wipe up any spilled fuel immediately.

1 Use regular UNLEADED gasoline with the generator engine Do not use premium gasoline Do not mix oil with gasoline.

2 Clean area around fuel fill cap remove cap. 3 Slowly add unleaded regular gasoline to fuel tank Fill to bottom of screen filter Be careful not to overfill (Figure 9).

4 Install fuel cap and wipe up any spilled gasoline

IMPORTANT: It is important to prevent gum deposits from forming in fuel system parts such as the carburetor fuel hose or tank during storage Fuel can attract moisture which leads to separation and formation of acids during storage Acidic gas can damage the fuel system of an engine while in storage To avoid engine problems the fuel system should be emptied before storage of 30 days or longer See the "Storage" section Never use engine or carburetor cleaner products in the fuel tank as permanent damage may occur.

Figure 9 Fuel Tank

DO NOT Fill Above Lip

Fuel

Fuel Tank

2.7 STARTING PULL START ENGINES

Never start or stop engine with electrical devices plugged into the receptacles AND devices turned on.

1 Unplug all electrical loads from the unit's receptacles before starting the engine.

2 Make sure the unit is in a level position (not to exceed 15° in any direction).

3 OPEN the Fuel Shut-off Valve (Figure 10). 4 Turn engine RUN/STOP switch to ON position (Figures 2C or 11).

5 Slide engine choke to the LEFT to FULL CHOKE position (Figure 12).

Figure 10 Fuel Shut-off Valve

6 To start engine firmly grasp the recoil handle and pull slowly until increased resistance is felt Pull rapidly up and away.

7 When engine starts move choke knob to 1/2-CHOKE position until engine runs smoothly and then fully into RUN position

If engine falters move choke back out to 1/2-CHOKE position until engine runs smoothly and then to RUN position.

NOTE:

If engine fires but does not continue to run move choke lever to FULL CHOKE and repeat starting instructions IMPORTANT: Do not overload the generator Also do not overload individual panel receptacles These outlets are protected against overload with push-to-reset-type circuit breakers If amperage rating of any circuit breaker is exceeded that breaker opens and electrical output to that receptacle is lost Read “Don’t Overload the

Generator” carefully.

Operation