Инструкция по эксплуатации Generac GP6000E — страница 9

Figure 3D Generator Controls (GP2600)

Figure 3E Muffler (GP2600)

2.2 HOURMETER (GP5000/GP6000 ONLY)

The Hourmeter tracks hours of operation for scheduled maintenance (Figure 4):
There will be a "CHG OIL" message every 100 hours The message will flash one hour before and one hour after each 100 hour interval providing a two hour window to perform service This message will actually begin flashing at 99 hours and disable itself at 101 hours again providing a two hour window to perform the service Every 200 hours the "SVC" icon on the lower left hand corner of the display will flash The message will flash one hour before and one hour after each 200 hour interval providing a two hour window to perform service When the hour meter is in the Flash Alert mode the maintenance message will always alternate with elapsed time in hours and tenths The hours will flash four times then alternate with the maintenance message four times until the meter resets itself.

- 100 hours CHG OIL Oil Change Interval (Every 100 hrs)

- 200 hours SVC Service Air Filter (Every 200 hrs)

NOTE:

The hour glass graphic will flash on and off when the engine is running This signifies that the meter is tracking hours of operation.

Figure 4 – Hourmeter

HOUR GLASS GRAPHIC

RESET BUTTON (IF EQUIPPED)

0000.0

2.3 CORD SETS AND CONNECTION PLUGS

2.3.1 230 VAC 16 AMP CEE 7/4 TYPE F RECEPTACLE

This is a 230 Volt outlet (Figure 5) protected against overload by a 16 Amp push-to-reset circuit breaker Use each socket to power 230 Volt AC single phase 50 Hz electrical loads requiring up to a combined 3,680 watts (3.6 kW) or 16 Amps of current Use only high quality well-insulated 3-wire grounded cord sets rated for 230 Volts at 16 Amps (or greater). Keep extension cords as short as possible preferably less than 5 meters long to prevent voltage drop and possible overheating of wires.

Operation