Инструкция по эксплуатации Generac GP6000E — страница 10

Figure 5 230 Volt AC 16 Amp CEE 7/4 Type F

Receptacle

2.3.2 230 VAC 30 AMP RECEPTACLE (GP5000/GP6000

ONLY)

Use this receptacle (rotate to lock/unlock) to operate 230 Volt AC 50 Hz single phase loads requiring up to 5000 watts (5.0 kW) or 6000 watts (6.0 kW) depending on the model The outlet is protected by one 30/25 Amp circuit breaker.

Figure 6 230 VAC 30 Amp Receptacle

2.3.3 ADAPTPER CABLE 50 HZ (GP5000/GP6000 ONLY)

Included with this generator is an adapter cable that plugs into the 30 Amp Twistlock receptacle on the generator control panel on one end and provides a 32 Amp IP44 CEE 2P+E socket on the other end (Figure 7).

Figure 7 – Adapter Cable

2.4 HOW TO USE THE GENERATOR

To obtain contact information for the nearest authorized dealer go to Locator.

Never operate in an enclosed area or indoors!

NEVER use in the home in a vehicle or in partly enclosed areas such as garages EVEN

IF doors and windows are open! ONLY use outdoors and far from open windows doors vents and in an area that will not accumulate deadly exhaust.

The engine exhaust fumes contain carbon monoxide which can you cannot see or smell

This poisonous gas if breathed in sufficient concentrations can cause unconsciousness or even death.

Adequate unobstructed flow of cooling and ventilating air is critical to correct generator operation Do not alter the installation or permit even partial blockage of ventilation provisions as this can seriously affect safe operation of the generator The generator MUST be operated outdoors

This exhaust system must be properly maintained Do nothing that might render the exhaust system unsafe or in noncompliance with any local codes and/or standards.

The manufacturer recommends installing a battery operated carbon monoxide alarm indoors according to the manufacturers instructions.

Operation