Инструкция по эксплуатации Vitek VT-1764 — страница 4

ENGLISH

• Do not cover the ventilation openings and avoid foreign objects getting inside them.

• Do not immerse the unit into water or other liquids.

• Do not move or tilt the unit during its operation.

• Always unplug the unit and pour out the water from the water tank when cleaning the unit or when you do not use it Unplug the unit before moving it to another place.

• Do not touch the power plug with wet hands.

• Before using the unit closely examine the power cord and make sure that it is not damaged Do not use the unit if its power cord is damaged.

• Do not disassemble the unit yourself if any malfunction is detected apply to the nearest authorized service center.

• Regularly clean the unit; be careful not to make any scratches on the sprayer.

• Store the unit out of reach of children.

FOR HOUSEHOLD USAGE ONLY

USING THE HUMIDIFIER Unpack the unit and remove the packing materials Examine the unit for damages Do not switch on the unit if there are any damages in it.

Note:
if the unit was subjected to negative temperatures before switching it on for the first time keep it at room temperature for 30 minutes

use the unit at temperatures from +5 to +40°С and relative humidity less than 80%

water temperature should not exceed +40°С.

Before switching on the unit make sure that you home electricity supply corresponds to the voltage specified on the body of the unit.

1 Take the handle (10) and remove the water tank (11) from the body (17).

2 Turn over the tank (11); unscrew the lid (15) by turning it anti clockwise Fill the water tank (11) with necessary quantity of water and screw the lid on (15) by turning it clockwise.

3 Set the filled tank (11) on the body of the unit (17) Wait for some time which is necessary to fill the operating chamber with water.

4 Plug in the humidifier the indication (21) will appear on the display (7); the room temperature (27) and humidity (28) will be displayed.

5 Switch on the humidifier by pressing the (5) “Power” on/off button the indication (21) will go out the display will switch to full brightness and the steam intensity indication (26) will light up.

Note:
each pressing of the control buttons will be accompanied with a sound signal.

if no button has been pressed during 30 seconds on the control panel or on the remote control the display brightness will decrease automatically.

6 To switch on the ionization mode press the (6) “Ozone” button the indication (25) will appear on the display (7) To switch off the ionization mode press the (6) “Ozone” button once again the indication (25) will disappear.

7 To switch on the heating mode press the (1) “Heating” button the indication (22) will appear on the display (7) In this mode the evaporated water will be 4

1764.indd 4

1764.indd 4

04.06.2010 14:11:17

04.06.2010 14:11:17