Инструкция по эксплуатации WORX Tools WU641 — страница 9

Finishing Sander

move it to the lever lock position Press the sanding paper around the base plate shape as tight as possible and fix the end under the other sanding paper clamp Check the sanding paper is square to the baseplate If not correct remove and refit it again Always ensure the sanding paper is tight over the baseplate and secured underneath both locked clamps This will ensure safe and efficient sanding performance 6 CHANGING HOOK & LOOP SANDING

PAPER The sanding paper and baseplate are provided with a hook and loop attachment system to allow quick and easy changing of the sanding and polishing accessories Remove any dust or other objects from the hook and loop on the baseplate and sanding paper Position the sanding paper evenly on the baseplate and firmly press down to attach them together If the sanding paperhas dust extraction holes you must align these with the holes in the baseplate otherwise the dust extraction will not function To remove the sanding paper lift one corner of the paper and pull it off from the baseplate (See C.3) 7 PAPER PUNCH If using sanding paper without dust holes use the paper punch to perforate the holes to ensure correct dust extraction Position the punch (10)
over the baseplate with the punch sides on the edges of the baseplate (See D) Press the punch into the baseplate to punch holes into the sanding paper Then remove the punch and check all the holes have been formed correctly.

8 DUST BAG Always operate your sander with the dust bag fitted For the best performance always empty the dust bag in time Open the zip and empty the dust from the bag To remove the bag slide the mounting bracket out and away from the sander (See E.1) To refit the bag firmly push the mounting bracket into the location on the sander housing (See E.2).

9 FLUSH SANDING FACILITY Your sander can sand flush on three sides of the baseplate which allows easy access to corners and edges of mouldings (See F).

10 ORBITAL SANDING Your sander operates in small circular rotations which allows efficient material removal Operate your sander in long sweeping movements across your workpiece and even across the grain For a finer finish always use a fine grain sanding paper and only move the sander in the direction of the grit and never across the grain Do not allow your sander to remain in the same position otherwise you will remove material and create an uneven surface.

WORKING HINTS FOR YOUR

FINISHING SANDER

If your power tool becomes too hot especially when used at low speed set the speed to maximum and run it with no load for 2-3 minutes to cool the motor Avoid prolonged usage at very low speeds Always use sand paper that is suitable for the material you want to sand Always ensure the work-piece is firmly held or clamped to prevent movement Any movement of the material may affect the quality of the sanding finish Start your sander before sanding and turn it off only after you stop sanding For the best results sand wood in the direction of the grain Do not start sanding without having the sandpaper fitted Do not allow the sandpaper to wear away it will damage the base-plate The guarantee does not cover base-plate wear and tear Use coarse grit paper to sand rough surfaces medium grit for smooth surfaces and fine grit for the final surfaces If necessary first make a test run on scrap material Use only good quality sandpaper The sandpaper controls the sanding efficiency not the amount of force you apply to the tool Excessive force will reduce the sanding efficiency and cause motor overload Replacing the sandpaper regularly will maintain optimum sanding efficiency.

RU-WU641-M-060818.indd 11

2006-8-18 13:54:44