Инструкция по эксплуатации WORX Tools WU641 — страница 8

Finishing Sander

not wet sanding.

21 Your tool is designed for general purpose light polishing of wood and metals.

22 Do not sand magnesium material due to the risk of fire.

Warning: Some dust particles created by power sanding sawing grinding drill and other construction jobs contain chemicals known to cause cancer birth defects or other reproductive harm Some examples of these chemicals are:

Lead from lead-based paints Crystalline silica from bricks and cement and other masonry products.

Arsenic and chromium from chemically treated lumber Your risk from these exposures varies depending upon how often you do this type of work:

To reduce your exposure to these chemicals:

Work in a well-ventilated area.

Work with approved safety equipment such as those dust masks that are specially designed to bag microscopic particles.

SYMBOLS

OPERATING INSTRUCTIONS 1 ON OFF SWITCH Depress to start and release to stop your tool.

2 SWITCH LOCK-ON BUTTON Depress on/off switch (1) then lock-on button (2)(See A) release on/off switch first and lockon button second Your switch is now locked on for continuous use To switch off your sander just depress and release the on/off switch.

3.VARIABLE SPEED CONTROL DIAL Adjust the dial(3) to increase or decrease the speed according to the material and sanding sheet specification to be used (also possible during no load operation)(See A) See the table below for general guidance on speed selection Avoid prolonged use at very low speed as this may damage your sander’s motor.

Sanding work

Grain

Speed setting(opm)

Coarse sanding

Precision sanding

Sanding down varnishes

8700~11000

Stipping paint

9800~11000

Touching up paintwork

7600~10000

Sanding wood

7600~11000

Machining vener

8700~11000

Sanding aluminium

7600~11000

Derusting metal

9800~11000

Sanding metal and steel

9800~11000

Sanding plexiglass

6500~8700

4 HAND GRIP AREA You can operate your sander with two hands (See B).

5 CHANGING STANDARD SANDING

PAPER To remove the sanding paper lift up the clamp lever and move away from the clamp lever lock (See C.1) The sanding paper clamp is now loose Repeat with the other clamp on the opposite side of your sander To fit new sanding paper insert approximately 5mm of one end of the sanding paper under the sanding paper clamp until the paper contacts the housing wall (See C.2) Lift up the clamp lever and 11

Read the manual

Warning

Double insulation

Wear eye protection

Wear hearing protection

Wear dust mask

RU-WU641-M-060818.indd 10

2006-8-18 13:54:43