Инструкция по эксплуатации WORX Tools WU400 — страница 9

Reciprocating Saw ENG

6 PIVOTING BLADE FOOT

The pivoting blade foot must be held firmly against the material being cut to reduce saw vibration blade jumping and blade breakage 7 FLUSH CUTTING

It is possible to make cuts extremely close to

floors walls and other difficult areas Insert the blade shank into the blade clamp with the blade teeth facing up (opposite to normal working position) This will make cuts closer to the work surface (See E) Using special flexible blades insert the blade into the blade clamp with the blade teeth facing down (normal working position) It will allow flush pipe cutting (See

8 WOOD CUTTING

Always ensure the work-piece is firmly clamped to prevent movement For easier control use low speed to start cutting then increase to the correct speed (See G).

9 METAL CUTTING

This saw has different metal cutting capacities depending upon the type of blade being used and metal being cut.

ALWAYS clamp the work down to prevent it from slipping.

Use a finer blade for ferrous metals and a coarse blade for non-ferrous metals.

When cutting thin gauge sheet metals ALWAYS clamp wood on both sides of the sheet This will give you a clean cut without excess vibration or tearing of the metal.

DO NOT force the cutting blade Forcing the blade will reduce blade life and cause the blade to break.

Note: We recommend that you spread a thin

film of oil or other coolant along the line of cut ahead of the saw This will allow easier operation and help extend blade life When cutting aluminum use kerosene.

10 POCKET CUTTING (Soft materials only)

Mark the pocket or internal hole to be cut out

Insert the special cutting blade with blade teeth facing down and clamp securely Angle the saw so that the back edge of the blade guard is resting on the work surface (See H.1 and H.2) Use a slow speed to start the cut to avoid breaking the blade but increase to correct speed once the cut has started With the blade guard held firmly against the work surface start a slow but controlled upward swing of the saw

The blade will cut into and through the material

Always ensure the blade is completely through the material before cutting the remainder of the pocket.

WORK HINTS FOR YOUR

RECIPROCATING SAW

If your power tool becomes too hot set the speed to maximum and run a no load for 2-3 minutes to cool the motor

Always ensure the work-piece is firmly held or clamped to prevent movement.

The blade guard must be held firmly against the material being cut to reduce saw vibration blade jumping and blade breakage.

MAINTENANCE

Your power tool requires no additional lubrication or maintenance There are no user serviceable parts in your power tool Never use water or chemical cleaners to clean your power tool Wipe clean with a dry cloth Always store your power tool in a dry place Keep the motor ventilation slots clean Keep all working controls free of dust If you see some sparks flashing in the ventilation slots this is normal and will not damage your power tool.

ENVIRONMENTAL

PROTECTION

Waste electrical products should not be disposed of with household waste

Please recycle where facilities exist

Check with your local authorities or retailer for recycling advice.

RU-WU400-M-060821.indd 9

2006-8-21 17:33:15