Инструкция по эксплуатации WORX Tools WU400 — страница 8

Reciprocating Saw ENG

WARNING: Some dust particles created by power sanding sawing grinding drill and other construction jobs contain chemicals known to cause cancer birth defects or other reproductive harm

Some examples of these chemicals are:

Lead from lead-based paints.

Crystalline silica from bricks and cement and other masonry products.

Arsenic and chromium from chemically treated lumber.

Your risk from these exposures varies depending upon how often you do this type of work To reduce your exposure to these chemicals:

Work in a well-ventilated area.

Work with approved safety equipment such as those dust masks that are specially designed to filter microscopic particles.

SYMBOLS

Read the manual

Warning

Wear eye protection

Double insulation

Wear hearing protection

Wear dust mask

OPERATING INSTRUCTIONS

1 ON/OFF SWITCH

Depress the button to start and release it to stop your tool.

2 VARIABLE SPEED CONTROL

Your tool is equipped with a variable speed controlled trigger switch The tool can be turned

“ON” or “OFF” by squeezing or releasing the trigger The blade plunger stroke rate can be adjusted from the minimum to maximum by the pressure you apply to the trigger Apply more pressure to increase the speed and release pressure to decrease speed (See A)

3 HAND GRIP AREAS

Always hold your saw firmly with both hands when operating (See A).

4 TOOL-LESS BLADE FITTING

To install the blade (See B and C) disconnect the saw from power supply If necessary extend the pivoting blade foot away from the blade clamp for easier access Pull the tool-less blade clamp lever (3) up with your thumb as shown Insert the blade into the saw’s blade clamp and make sure that the blade attaches to the blade pin inside the clamp Push down blade clamp lever (3) ensure the blade is locked securely in place

To remove Blade (See B and C)

Disconnect saw from power supply If necessary extend the pivoting blade foot away from the blade clamp for easier access First pull the blade clamp lever (3) up with your thumb and then pull the blade out of the blade clamp.

5 PIVOTING FOOT PLATE ADJUSTMENT

If you need to reduce the cutting capacity of your tool (depth of cut) the pivoting foot plate (4) may be adjusted as follows

Press the pivoting foot plate release button (6) on the underside of the front housing (See D) Slide the pivoting foot plate forward or backwards to give the required distance from the end of the blade (See D) Release the pivoting foot plate release button The pivoting foot plate is now locked in position but will continue to pivot as it follows the work surface during the cut The distance from the front of the foot plate to the tip of the blade (on the longest part of the cutting stroke) equals the cutting capacity of the tool.

RU-WU400-M-060821.indd 8

2006-8-21 17:33:14