Инструкция по эксплуатации WORX Tools WU400 — страница 7

Reciprocating Saw ENG

changing accessories or storing power tools Such preventative safety measures reduce the risk of starting the power tool accidentally.

d) Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool Power tools are dangerous in the hands of untrained users.

e) Maintain power tools Check for misalignment or binding of moving parts breakage of parts and any other condition that may affect the power tools operation If damaged have the power tool repaired before use Many accidents are caused by poorly maintained power tools.

f) Keep cutting tools sharp and clean

Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control.

g) Use the power tool accessories and tool bits etc in accordance with these instructions and in the manner intended for the particular type of power tool taking into account the working conditions and the work to be performed Use of the power tool for operations different from intended could result in a hazardous situation.

5 SERVICE

a) Have your power tool serviced by a qualified repair person using only genuine replacement parts This will ensure that the safety of the power tool is maintained.

6 SPECIFIC SAFETY RULES

a) Always wear safety glasses or eye shields when using the reciprocating saw Everyday eyeglasses have only impact-resistant lenses; they are NOT safety glasses Following this rule will reduce the risk of serious personal injury.

b) Always wear a face mask or dust mask

Following this rule will reduce the risk of serious personal injury.

c) Always wear hearing protection during extended periods of operation Following this rule will reduce the risk of serious personal injury.

d) Hold tool by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord Contact with a “live” wire will make the exposed metal parts of the tool “live” and shock the operator.

e) Keep your hands away from cutting area DO NOT reach under the material being cut because the nearness of the blade to your hand is hidden from your sight.

f) Do not use dull or damaged blades Bent blades can break easily or cause kickback.

ADDITIONAL SAFETY

POINTS FOR YOUR DRILL

1 Remove the plug from the socket before carrying out any adjustment servicing or maintenance.

2 Fully unwind cable drum extensions to avoid potential overheating.

3 When an extension cable is required you must ensure it has the correct ampere rating for your power tool and is in a safe electrical condition.

4 Ensure your mains supply voltage is the same as indicated on the rating plate.

5 Your tool is double insulated for additional protection against a possible electrical insulation failure within the tool.

6 Always check walls floors and ceilings to avoid hidden power cables and pipes.

7 After long working period external metal parts and accessories could be hot.

8 Always hold the saw firmly with both hands when operating.

9 Only withdraw the blade from the cut when the blade has been stopped moving.

10 The pivoting blade foot must be held firmly against the material being cut to reduce saw vibration blade jumping and blade breakage.

11 Before cutting check the cutting line is free of nails screws etc.

12 If possible ensure the work-piece is firmly clamped to prevent movement.

RU-WU400-M-060821.indd 7

2006-8-21 17:33:12