Инструкция по эксплуатации ViTESSE VS-651 — страница 4

STEAM IRONING

Note: 1 Place the iron on a level horizontal ironing board. 2 Set the steam control knob to “0” position and then fill the reservoir with clean tap water refer to above filling instruction 3 Connect the appliance to a suitable power socket set the temperature control dial to ”MAX” position The heating indicator light will light up which indicate that the unit is being heated up When the required temperature is reached the heating indicator light will turn off 4 For every first use press down the Turbo Steam Button several times continuously and then press down the self-clean button for about 10 seconds to clean the steam chamber 5 Set temperature control dial to desired position according to different fabrics put the steam control knob to ” “ position and then steam will come out from steam vents of soleplate During steam ironing it is normal that the heating indicator light cycle from ON to OFF and the OFF to ON It is because the appliance is automatically heat preservation 6 When setting the temperature control dial on ” l

” or “ l l

” position there are no steam go out of the soleplate since the temperature of soleplate is so low that it can not produce steam 7 After use turn steam control knob to “0” position disconnect the appliance from power socket 8 Before storing please allow the unit completely cool down 1 It is normal that a “pong” sound produced it because that the anti-drip function is automatically activated 2 Every first time use the iron should be pre-heated for about 2 minutes During steam ironing stage steam may be stopped escaping from the outlet resulting from the anti-drip function being activated Just to turn the steam control knob to smaller steam position or temperature control dial to larger position it will be resumed again

DRY IRONING

Note:

TURBO STEAM IRONING

Caution:

1 Place the iron on a level horizontal ironing board. 2 Set the steam control knob to “0” position. 3 Fill reservoir with water as indicated in above filling instruction. 4 Connect the appliance to suitable power socket and then set temperature control dial to the desired position according to different fabrics The heating indicator light will light up which indicate that the unit being heated up When the heating indicator light turn off the required temperature is reached It is ready for dry ironing 5.If water spray is necessary press down the spray button two or three times in quick succession water can be sprayed evenly in the fabric 6 After use turn temperature control dial to “Min” position and disconnect the appliance from main socket

When changing your temperature control dial from higher settings to lower it is proposed that not to start ironing immediately since there may be any burns caused on your fabrics by high temperature Please wait for the indicator light illuminate again and then start ironing

The Turbo of Steam feature provides additional steam for removing stubborn creases 1 Set the ”steam control knob” to “0” position and then fill the reservoir with clean tap water refer to above filling instruction 2 Connect the appliance to a suitable socket outlet set the temperature control dial to ” MAX” position The heating indicator light will light up which indicate that the unit being heated up When the heating indicator light turn off the required temperature is reached 3 Press the turbo steam button two or three times in quick succession to obtain more powerful turbo steam 4 It is normal that a small amount of water may be ejected from the sole-plate when pressing burst steam button so frequently that temperature of sole-plate will be down accordingly It is supposed to stop pressing turbo steam button and allow it to heat up again 5 After use turn steam control knob to “0” position disconnect the appliance from power socket 6 Before storing please allow the unit completely cool down when using turbo steam ironing should turn steam control knob to “0” position