Инструкция по эксплуатации ViTESSE VS-651 — страница 3

IRONING TEMPERATURE SETTING GUIDE 1 Follow up the ironing instructions on the garment label If there is not any instruction label but you know what kind of the fabric is please refer to the FABRIC SETTING CHART described in this instruction manual 2 The fabric setting chart is only valid for plain fabrics and not for materials to which finishes glosses etc have been applied Textile to which some kind of finish has been applied (gloss crinkle relief etc.) is best ironed at lower temperature 3 First sort laundry according to ironing FABRIC SETTING CHART: wool with wool cotton with cotton etc 4 The iron heats up more quickly than it cools down Therefore start ironing articles that need to be ironed at the lowest temperature such as those made of synthetic fibres 5 If the fabric consists of various kinds of fibres always select the temperature required by the most delicate fibres i.e the lowest temperature If for example an article consists of 60% polyester and 40% cotton according to the fabric setting chart it should be ironed for polyester and without steam 6 If you do not know what kind of fabric the article is made of iron a piece of the material which is not visible when you wear to find out the appropriate temperature for your articles 7 Pure woolen fabrics (100% wool) should be ironed with the iron setting to steam ironing position It is advisable to set the temperature control dial to “Max” position and use a dry pressing cloth 8 When steam ironing woolen fabrics shiny patches may occur You may prevent this by turning the article inside out and ironing the reverse side 9 After using of steam ironing for cotton fabrics do not iron articles required by lower temperature (such as nylon etc.) immediately It is advisable to adjust the temperature dial to the lower setting waiting for about 2-4 minutes till the power indicator light turn off and then you can start ironing

HOW TO FILL RESERVOIR

Note:

Make sure that the iron is unplugged from main socket or steam control knob is set at “O” position before filling water into the reservoir 1 Set the steam control knob to”0”position as shown in figure 2 2 Open inlet cover and take Anti-calc box upwards out of the filling hole (Fig.3). 3 Using a cup slowly pour tap water or distilled water into the reservoir as show in figure 4 Never to fill beyond the Max filling line 4 Replace the Anti-calc box back into the filling hole as show in figure 5. 5 Hold the iron in horizontal direction and then move the iron front and back for about 30 seconds so that limescales in water can be purified by the ion exchange resin in the Anti-calc box

When using distilled water you can mix it with tap water in a proportion of 50%

Fig.2

Fig.3

Fig.4

Fig.5

Synthetic

Silk/Wool

Cotton

Fabric Setting

Temperature Setting

Dr such as Nylon Acrylic Polyester y iron for lower ironing temperature,

Dr temperature such as Silk Wool y iron for mid ironing

Dr such as Cotton/Linen y iron for higher temperature,

Steam iron for all fabrics

Ironing Instruction

FABRIC SETTING CHART