Инструкция по эксплуатации Vitek VT-6405 — страница 8

English

Barometric pressure check As soon as atmospheric pressure and altitude units and the altitude value are set the meteorological station will automatically switch to the temperature and humidity displaying mode To check the barometric pressure press the

PRESSURE/ALTITUDE button to display pressure indications Press this button once again to display altitude To return to the temperature and humidity displaying press the

MEMORY button.

Barometric pressure correction Barometric pressure will be corrected by means of measuring of the barometric pressure or altitude.

Barometric pressure measuring 1 Press the

PRESSURE/ALTITUDE button to display barometric pressure indications.

Press and hold the UNIT or PRESSURE/ALTITUDE button to measure barometric pressure or its value correspondingly

Use the

▼/SEARCH or

MEMORY button to set the measuring units/desired value

Press the UNIT or PRESSURE/
ALTITUDE button to confirm.

Altitude value will be changed according to the new barometric value

Altitude measuring

1 Press the PRESSURE/ALTITUDE button twice to display altitude

Press and hold the UNIT or

PRESSURE/ALTITUDE button to measure altitude or its value correspondingly

Use the

▼/SEARCH or

MEMORY button to set the measuring units/desired value

Press the UNIT or PRESSURE/

ALTITUDE button to confirm.

5 Barometric value will be changed according to the new altitude

TEMPERATURE AND HUMIDITY INDICATIONS

With every pressing of the

▲/MEM-

ORY button switching between the displaying of the following parameters appears:

Current temperature and humidity

• Minimal temperature and humidity

• Maximal temperature and humidity

Note: during the operation of the remote sensor at the temperature below 0° C voltage of its batteries can lower reducing thus the operating radius of its transmitter

Temperature changing tendencies Temperature changing tendencies are displayed as arrows (growing constant falling down) near the corresponding data.

Data channels switching Press the CHANNEL button to switch between the data channels from the remote sensors (1 ) indoors (IN)

6405IM.indd 8

12.11.2008 11:21:13