Инструкция по эксплуатации Vitek VT-6405 — страница 5

English

DESCRIPTION Basic unit (pic.1)
1 Display The SNOOZE

button Switching on the LCD-display signal and backlight repeat function

5 the

+ buttons

Value changing of the entering characteristic

The MODE

button – switching between display sectors confirmation of the value 6,8

AL1 AL buttons

Displaying of alarm actuation alarm switching on/off

7 The

°С/°F buttons Switching of temperature units 9

Hole for fastening of the unit on the wall

CHANNEL button Switching of channels importing data from remote sensors

11 The

▼/SEARCH button

Searching a signal from the remote sensor

The UNIT button Selecting pressure measuring units

1 The

▲/MEMORY button

Displaying of maximal/minimal temperature values registered by the basic unit and the remote sensor 1 The PRESSURE/ALTITUDE button

– Displaying of pressure/altitude values and entering the setup mode

15 The RESET button 16 Battery compartment lid (

for batteries “АА”)

17 Table support 18 Net adapter jack (DC7,5 V)

Remote temperature sensor (pic.2)

L LED on Front Panel

When device is transferring data LED blinks one time.

When battery replacement is required LED blinks two times.

M Battery Compartment

Compartment is intended for
batteries of UM- or АА type.

N Reset Button (RESET)

This button is used to reset sensor after changing channel number.

O Button for switching between

Celsius/Fahrenheit scale

P Channels switch (CHANNEL)

This button is used for selecting channel of data transfer before batteries installation.

Q Hole for Mounting Device to Wall

BEFORE OPERATION For proper operation of the unit insert the batteries firstly into the battery compartment and then into the base unit Set the remote sensor within effective data transfer radius and as close as possible to the base unit Place the based unit and the remote sensor in places with minimal interferences for better data transfer.

Take into consideration that the data transfer radius depends on the construction material of partitions of the building and its quantity Try out several variants of the remote sensor and base unit allocation In spite of the fact that the remote sensor is protected from meteorological conditions it should be set in a way that direct sun-

6405IM.indd 5

12.11.2008 11:21:12