Инструкция по эксплуатации Vitek VT-6405 — страница 6

English

light rain or snow does not get it House mechanisms (door bell signal system etc.) can cause interferences while reception by the base unit of data signals from the remote sensor It is normal and does not influence the general operation Transfer and reception of the data signal will resume immediately after the temporary interferences disappear

Placing batteries in the remote sensor 1 Unscrew the screws on the battery compartment lid.

Select data transfer channel using the channel switch.

Set batteries following the polarity.

Close the battery compartment lid and tighten up the screws.

Connecting the net adapter to the base unit/placing batteries into the base unit 1 Open the battery compartment lid.

Set batteries (“ААА” 1.5 V) following the polarity.

Close the battery compartment lid and tighten up the screws

Make sure that the adapter voltage corresponds to the voltage in the mains 5 Using the external power supply jack connect the net adapter to the base unit supplied (7,5

V DC).

Note:
The base unit is intended to be powered by the external power supply;
battery supply is a backup variant

If the net adapter is disconnected from the base unit the following symbol will appear on the display ( )

Battery replacement When the corresponding indication about battery discharge appears you should replace the batteries

Note: While long operation of the remote sensor at high or low temperatures its voltage can lower reducing thus the operating radius of its transmitter

STARTING OPERATION After inserting of the batteries in the remote control it will start data transfer (temperature and humidity) with about 5 second intervals In about two minutes after inserting of the batteries in the base unit or connecting to the mains it will start in its turn searching of a signal from the remote control In ten minutes after receiving data they will appear on the display of the base unit Data updating is performed automatically in 5 seconds

If there is no signal from the remote sensor the “ “symbols will appear on the display For synchronization of the base unit and the remote sensor press and hold the

▼/SEARCH button during seconds.

Note: Repeat this procedure if the registrations of the remote sensor differ from those of the base unit 6405IM.indd 6

12.11.2008 11:21:13