Инструкция по эксплуатации Vitek VT-3476 — страница 15

4 Press the PLAY/PAUSE button (14). 5 Move the FUNCTION switch to CD. 6

Wait one hour.

The sound skips

1 The disc is severely damaged. 2 The device is being moved.

1 Change discs. 2 Stabilize the device.

TAPE RECORDER

Tape does not go in Tape holder does not shut The tape is upside down Put the tape right side up.

The tape will not play

1 The tape is defective. 2 The PAUSE button (4) is pressed. 3 The batteries are low. 4 The tape has grown slack.

1 Switch tapes. 2 Press the PAUSE button (4) again. 3 Replace them. 4 Use a pencil to take up the slack.

Cannot record The tabs are removed on the tape Switch tapes.

Sound is distorted Erasure is incomplete

• The heads are dirty.

- You are using a high position or metal tape.

- Clean them.

- Use a normal tape.

RAIDIO

Too much static

• Receive electrical interference.

- Receiving interference from motors fluorescent lights or television.

• Plug in the power cord securely.

- Move the device to a different place.

- Turn off the TV.

- Adjust the antenna.

SPECIFICATION

CD Player

Sampling Frequency Pick-up 44.1 kHz Non-contact optical pick-up (Semiconductor laser)

Radio

Reception Frequency FM: 88-108 MHz AM: 530-1600 kHz

File System Compatibility Sampling Frequency Bit rates ISO 9660 (level 1) Joliet 32 kHz 44.1 kHz 32-
320 kbps

Tape Recorder

Track Motor Heads: 4-track 2-channel stereo Electronic governor DC motor Magnetic head for erasure AC bias for recording Fast-wind Time: Approx sec (C-60 cassette)

Microphone

Omnidirectional microphone

GENERAL

Speakers cm x 2 (4Q)
cm x 2 (8Q)

Max Output

2W + 2W(JEITA/DC)

Output Terminals: Phone jack (Stereo mini jack)

mW (Ohm)

Power Supply: AC 230 V~50Hz

DC 12 V(D-sizex8)

Power Consumption: 15 W Dimension:

432 (W) x 157 (H) x 231 (D) mm

Technical characteristics may be changed by the manufacturer without prior notice.

SERVICE LIFE – NO LESS THAN 5 YEARS

GUARANTEE Details regarding guarantee conditions can be obtained from the dealer from whom the appliance was purchased The bill of sale or receipt must be produced when making any claim under the terms of this guarantee.

This product conforms to the EMCRequirements as laid down by the Council Directive 89/336/EEC and to the Low Voltage Regulation (23/73 EEC)

ENGLISH

3476.qxd 01.04.2005 22:13 Page 15