Инструкция по эксплуатации Vitek VT-3476 — страница 14

the cassette tape holder and insert a tape.

• Load the tape with the side you want to record on facing you.

2 Close the cassette tape holder until you hear it click shut.

• Stop the tape in the position where you will start recording.

3 Selecting the recording function (source) When recording a CD (CD synch record):
Select the track you wish to record from.

• To only record specific tracks set a program

To record the radio:
Tune in to the station you want to record To record sound from an Internal microphone:
Move the FUNCTION switch to TAPE/OFF.

4 Press the RECORD button (

) The PLAY button (

) is also depressed at the same time and the recording starts.

• When recording a CD (CD synch record) the recording and the CD start at the same time.

• You can start recording from the middle of a song when you press the RECORD button (

while the CD is paused.

• When the tape comes to the end tape recording automatically stops.

• When in CD synch record you can pause CD

play by pressing the STOP/EJECT button (

Press the PLAY/PAUSE button (

) to continue CD play Pressing the STOP button (

) to stop CD play.

Important!

- CD synch record is the function which starts play automatically when you press the RECORD button (

• When you press the RECORD button (

) the play button is also depressed at the same time which may produce resistance more than normal This is not a malfunction.

STOP TAPE RECORDING

Press the STOP/EJECT button (

• When in CD synch record you can pause CD

play by pressing the STOP/EJECT button (

WHEN BEATS OCCUR DURING RECORDING

When recording the radio beats may occur If this occurs move the BEAT CANCEL switch on the rear of the device to a position in which the beats cannot be heard (1 or 2). Note:

• What you have recorded is for your own personal enjoyment It is under copyright and cannot be used for any other purpose without the permission of the copyright holder.

CARE AND MAINTENANCE

Cleaning the tape heads

When you play or record on a tape and;

• the sound has degraded • the recording is not clear • the tape has not been completely erased • the tape gets caught in the device most likely dirt has accumulated on the heads pinch roller or capstan Purchase a cleaning kit (or cleaning tape) and clean the heads You should clean the heads once every 10 hours of use Press the STOP/EJECT button (

) to open the cassette tape holder and wipe the area displayed in the illustration.

• After using the device for an extended period of time the heads will magnetize and cause static or degraded sound If this occurs use a commercial demagnetizer to demagnetize the heads

Cleaning the device

Use a soft cloth to lightly wipe dirt from the device When the device is extremely dirty use a cloth moistened with a diluted neutral cleaning solution to wipe the dirt away and wipe again with a dry cloth.

• Do not use benzene or thinner on the device.

Additionally do not pour volatile chemicals on the device case such as insecticides.

TROUBLESHOOTING

Confirm the following things before considering repairs.

No sound 1 The power cord is loose. 2 The batteries are misaligned. 3 The batteries are low. 4 The volume is down. 5 The headphones are in.

1 Securely plug it in. 2 Align them. 3 Replace them. 4 Adjust the volume. 5 Remove them.

CD/MP3 Player

Will not play 1 The disc format is incorrect. 2 The disc is upside down. 3 The disc is dirty. 4 The disc is paused. 5 The function is not correct. 6 The lens is fogged up.

1 Load the correct format disc. 2 Turn label side up. 3 Clean it

ENGLISH

3476.qxd 01.04.2005 22:13 Page 14