Инструкция по эксплуатации Saturn ST-VC0262 — страница 6

The filtration system in the dust container is composed of HEPA mesh and HEPA filter

The HEPA filter and the HEPA mesh should be cleaned regularly Cleaning is best done when emptying the dust container To do this follow the instructions in the Emptying dust container section

Switch off the vacuum cleaner and disconnect the plug from the mains To do this always pull on the plug and not on the cable.

Hold the HEPA mesh and rotating the

HEPA mesh by anti-clockwise direction the HEPA mesh and HEPA filter can be taken out together It is recommended to clear the dust on HEPA filter away with the cleaning brush under the bottom cover of the dust container firstly

And if necessary washing the HEPA filter with clear water airing naturally Generally the HEPA mesh doesn’t need clean.

Caution!

Only ever clean the filter with clean water and do not use soap or detergent

These would destroy the filter.

Place the HEPA filter and HEPA mesh back in the HEPA cover (or replace with a new one) and fit it into the dust container Then fit the dust container back into position in the cyclone dust container until it snaps into place Your cyclone vacuum cleaner is now ready for use again.

Motor protection valve

The appliance has the protection valve when the dust cup is full of dust HEPA filter is blocked or the air path is blocked the protection valve Will turn on automatically avoiding motor overheat in order to prolong the life of motor.

Motor protection filter

The motor protection filter cleans the air that sucked in before it enters the motor The air is cleaned of fine dusts mites bacteria and viruses This prevents dirt or dust particles from getting into the motor or the surrounding air.

Cleaning the exhaust air filter

The exhaust air filter cleans the air a final time before it leaves the vacuum cleaner You can clean the exhaust air filter as follows:

Switch off the vacuum cleaner and disconnect the plug from the mains To do this always pull on the plug and not on the cable.

Rotating the exhaust air grill by anticlockwise direction and open the exhaust air grill (this is on the left of the appliance.)

The exhaust air filter is visible when the grill has been opened.

Rinse the filter under cold running water and allow dry.

Caution!

Only ever clean the filter with clean water and do not use soap or detergent

These would destroy the filter.

Put the exhaust air filter back into place (or replace with a new one) and place in the grill.

Holding the exhaust air filter grill and rotating it by clockwise direction close the exhaust air filter grill.

Care and maintenance

Cleaning the vacuum cleaner

To clean the appliance casing switch off and disconnect the plug from the mains socket.

Danger!

Never expose the vacuum cleaner to the effects of the weather (rain etc.) No parts may be washed in a dish washer.

The casing dust collecting chamber and filter chambers of the vacuum cleaner can be wiped with a damp cloth if required No liquid must enter the vacuum cleaner in the process Never use strong cleaning substance(scouring liquids thinners) since these will corrode the plastic surface Only place the plug back in the mains socket when you have made sure that all the parts are thoroughly dry.

Hair and fluff may gather on the running wheels and on the floor nozzle of the vacuum cleaner in time.

You should remove these to ensure that handling of the vacuum cleaner is always easy.

Correct disposal of this product

This marking indicates that this product should not be disposed with other household wastes throughout the EU To prevent possible harm to the environment or human health from uncontrolled waste disposal recycle it responsibly to promote the sustainable reuse of material resources To return your used device please use the return and collection systems or contact the retailer where the product was purchased They can take this product for environmental safe recycling.

In the event of problem

Trouble-shooting

Faults can occur on all electrical equipment This must not necessarily be due to a defect in the device itself So check first with table if the fault can be dealt with.

PROBLEM

POSSIBLE

CAUSES

SOLUTIONS

TIPS

The secondary valve is open.

Close the secondary valve

An object is blocking the suction pipe

Check the suction tube the handle area suction pipe and the nozzle in use for blockages.

Weak suction

Filters are not fitted properly or are blocked

Fit a new filter

Appliance does not work.

Device is not properly plugged into the mains

Check that the mains plug has been inserted properly Also check whether the power socket is in order (e.g use an electric torch) Check the fuses!

Automatic fuses in the fuse box

Danger!

Never try to repair a defective device or a device you believe to be defective by yourself You can put both yourself and