Инструкция по эксплуатации Saturn ST-VC0262 — страница 5

Operation

Vacuum cleaning

Before using the appliance first roll out a sufficient length of electric flex cable and plug into the mains socket The yellow mark on the electric flex cable is the maximum length that must not be exceeded.

To switch on the appliance press the

ON/OFF switch button on the casing with your foot or by hand Pull the device behind you like a sledge when working with it.

Important!

Do not suck up toner plaster cement stone dust or drill dust The sucking up of these materials blocks the filter.

Regulating the suction power

The ON/OFF switch button is also used for the suction regulating You can set the suction power on the appliance individually as your request by using the suction regulator (rotating the button by clockwise direction means the suction power from

MIN to MAX)

We recommend using minimum suction power for delicate materials.

Select medium suction power for mattresses upholstered furniture and carpets Select maximum suction power for tiled wood and other robust floors.

Secondary air valve

The secondary air valve is at the handle

* Opening: pull upwards

* Closing: push downwards

You can adjust the suction power by using the secondary air valve

The wider the secondary air valve is opened the less the suction power and vice-versa.

Open the secondary air valve to prevent curtains and the like from being sucked in.

Choose:

Minimal suction power for curtains and sensitive materials

Medium suction power for upholstery cushions mattresses carpet floors

Maximum suction power for tiled wooden and robust floor surfaces with heavy soiling.

After vacuum cleaning

Switch off the appliance when you have finished cleaning:

1.To do this press the ON/OFF

Accessories storage box

switch button on the appliance with your foot or by hand.

2.After this pull the mains plug from the socket 3.

To roll in the cable press foot pedal and hold it in position The cable will be rolled back automatically onto the installed cable drum and disappear completely into the appliance up to the plug.

4.The 2 in 1 nozzle and round brush can be kept in the accessories storage box of the appliance after use.

Hepa filter cleaning system

The cyclone vacuum cleaner function without needing a dust bag The sucked up dirt is forced into the dust container by force of the air jet instead The air is cleaned by a washable permanent filter (HEPA filter) in the dust container motor protection filter and an exhaust air filter.

Caution!

Never vacuum clean without a filter or with a damaged filter The dust that is sucked up would force its way into the appliance and damage the motor

Clean dust dirt in the dust container is very simple.

Emptying dust container

You can easily see with the transparent dust container when it must be emptied.

1.Switch off the vacuum cleaner and disconnect the plug from the mains To do this always pull on the plug and not on the cable.

You can hold the dust container release button then pull out the dust container from the body and carry it to the waste bin.

2.3.

The empty button is located on the dust container that you can use to open and empty it automatically To do this hold the dust container over your dustbin and press on the empty button 3 After emptying it clean the HEPA filter again if necessary (see also Cleaning the HEPA filter below) After this rinse out the dust container and wipe it dry.

Cleaning the HEPA filter