Инструкция по эксплуатации Saturn ST-CC0229 — страница 4

3 Switch out Cage Knob Lift the rod to proper height and then close Cage

Knob 4 Cut Fixed Tube of Steam Hose into

Fixed Stopper of Steam Hose and then fix it Re fig 5 Place the hose head on hanger.

6 Twist off the cap of the water tank then put water into the water tank.

7 Screw the cap then put the water tank into the unit.

8 Plug in and turn the switch to the

“1” gear then the indicator lights up and small steam will throw out; turn the switch to the “2” gear and big steam will throw out When you finish using turn the switch to the “0” gear remove the plug and store the unit.

Damaged Checking & Reason

PHENOME

CAUSE

RESOLUTI

No working Electrocircuit breakdown;

Plug disconnectio n;

No light of switch;

Fuse burned

Take it to a qualified service person for examination and repair

Big noise from the hose and low steam

Steaming in low position

Straighten hose up and left condensatio n is free to flow back into steamer.

The water drips from the steam head

The steam head damaged;

Steaming not in an upright position

Exchange a new steam head

Straighten hose up.

Water and steam drips from hose connecting position

Seal-ring damaged;

No tight of hose connecting position

Exchange a new sealring

Screw tightly of connecting position

Water flow out from the water tank

Water tank broken or has hole

Exchange a new water tank

Water in water tank became hot

Copper water pipe was stopped up

Clean up the deposits

Low steam than usual

Low pressure voltage;

Water tube had been shut-up

Set up manostat

Remove water deposits with fresh water or liquid cleaner

Water tank deformed

Infuse overhot water or some chemical agent

Maintain using the tank

Exchange new water tank

No steam but lamp is light

Steam generator is broken;

Some electronic component is broken

Take it to a qualified service person for examination and repair

No steam

Steam condensed in steam pipe

Lift the brush head and steam pipe so that condensed water can come into the water tank

Irregular

Steam

Steam condensed in steam pipe and brush head

Lift the brush head and steam pipe so that condensed water can come into the water tank

Water drop from brush head

Steam condensed in steam pipe

Lift the brush head and steam pipe so that condensed water can come into the water tank

Indicator light off

Not plug in or power switch is in off position

Put the plug in or press switch

Indicator light keeps on

No water in water tank

Auto constant temperatur e knob is off

The cap of water tank not pressed tightly

Fill water into the water tank

Adjust auto constant temperature knob clockwise

Tighten the cap of water tank

Smelled steam

New machine

Dirty inside of water tank

Remove the cap of water tank and put the water tank in shadow 12 hours

Clean the water tank by clean water

Indicator light on but no wind no fog

Water too much than water level

Pour some water out

Humidifier steam lower than usual

Transducer scaling

Dirty water or water stored too long

Clean the transducer

Change the water in water tank

Humidifier steam

Check if the appliance

Change the machine