Инструкция по эксплуатации Saturn ST-CC7109

IRON

Dear Buyer!

We congratulate you on having bought the device under trade name “Saturn” We are sure that our devices will become faithful and reliable assistance in your housekeeping.

Avoid extreme temperature changes

Rapid temperature change (e.g when the unit is moved from freezing temperature to a warm room) may cause condensation inside the unit and a malfunction when it is switched on In this case leave the unit at room temperature for at least 1.5 hours before switching it on.If the unit has been in transit leave it indoors for at least 1.5 hours before starting operation.

IMPORTANT SAFETY INSTRUCTIONS

When using your flatiron basic safety precautions should always be followed including the following:

READ ALL INSTRUCTIONS BEFORE

USING

1 Use iron only for its intended use.

2 To protect against a risk of electric shock do not immerse the iron in water or other liquids.

3 The iron should always be turned to

Off before plugging or unplugging from outlet Never yank cord to disconnect from outlet; instead grasp plug and pull to disconnect.

4 Do not allow cord to touch hot surfaces Let iron cool completely before putting away Loop cord loosely around iron when storing.

5 Always disconnect iron from electrical outlet when filling with water or emptying and when not in use.

6 Do not operate iron with a damaged cord or if the iron has been dropped or damaged To avoid the risk of electric shock do not disassemble the iron take it to a qualified serviceman for examination and repair Incorrect reassembly can cause a risk of electric shock when the iron is used.

7 Close supervision is necessary for any appliance being used by or near children Do not leave iron unattended while connected or on an ironing board

It is not advised to use this appliance by children under 14.

8 Burns can occur from touching hot metal parts hot water or steam Use caution when you turn a steam iron upside down – there may be hot water in the reservoir.

9 If the malfunction indicator goes on the flatiron is not operating normally

Disconnect from the power supply and have the flatiron serviced by qualified service personnel.

SPECIAL INSTRUCTIONS

1 To avoid a circuit overload do not operate another high wattage appliance on the same circuit.

2 If an extension cord is absolutely necessary a 10-ampere cord should be used Cords rated for less amperage may overheat Care should be taken to arrange the cord so that it cannot be pulled or tripped over.

SAVE THESE INSTRUCTIONS.

More specifically:

DO NOT let children or untrained persons use the appliance without supervision.

NEVER immerse the iron cable or plug in any liquid.

DO NOT leave the hot iron touching fabrics or very inflammable surfaces.

DO NOT leave the appliance unnecessarily plugged in Disconnect the plug from the mains when the appliance is not being used.

NEVER touch the appliance with wet or damp hands.

DO NOT use the power cord or the appliance in order to pull the plug out of the socket.

DO NOT leave the appliance exposed to the weather (rain sun etc ).

DO NOT leave the iron without supervision when it is connected to the power supply.

DO NOT fill the reservoir with water before removing the plug from the socket.

PLEASE NOTE!

Do not use chemical additive scented substances or decalcifiers Failure to comply with the above-mentioned regulations leads to the loss of guarantee

DESCRIPTION OF DEVICE

(1) Spray organ (2) Filler door (3) Steam dial (4) Spray button (5) Shot-steam button (6) Auto shot off indication light (7) Supply cord (8) Cord bushin (9) Transparent water tank (10) Thermostat knob for temperature regulation (11) Self-cleaning button (12) Plate with steam vents (13) Maximum filling level (14) Water measure