Инструкция по эксплуатации Saturn ST-CC0229 — страница 3

could cause a risk of fire electric shock or injury to persons when the appliance is used.

11 Indoor use only.

12 The appliance only can be connected with sockets with earth wire.

13 Water should be put into water tank before setting power.

14 Burns could occur from touching hot parts hot water or steam use cars when you empty a steam appliance there may be hot water in the reservoir.

15 After using wait for unit natural cooling.

16 After using pull out the power plug from socket.

17 Do not pull out steam pipe during use.

18 The power plug shall be pulled out from socket when filling water and cleaning.

19 There’s no heating device in the steam spray board So do not take the brush down during using.

20 This appliance is not intended for use by persons (including children) with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

21 Children should be supervised to ensure that they do not play with the appliance.

22 Don’t put the appliance on the desk or chair The appliance only can be put on the ground.

23 Be careful of the hot little water coming out from the brush before using.

24 Do not pull out the steam pipe during use.

25 Do not let the water flow into the body from water outlet in order to avoid damaging the inner parts.

26 Do not remove the water tank when humidifier working.

WARNING:

Do not clean the appliance under tap water.

Be careful of the hot steam from steam pipe.

Do not bend the brush head.

Do not pull out the power cord from outlet by wet hand.

Steamer Parts Diagram

NAME OF

PARTS

Fixed sheath for rod-set

Fixed knob for rod-set

Panel 4

Fixed rack for copper tube

Fixed shelves for copper tube

Indicator 7

Power switch 8

Indicator 9

Upper of body 10

Bottom of body 11

Water drain pipe nut

Water inlet pipe 13

Increase weight 14

Water tank 15

Water tank cover

360° truckle 17

Wheel

DRAW-

ING NO.

NAME OF PARTS

Against slide hose hanger

Highest section of rod 3

Fixed sets of upper rod 4

Lock button 5

Upper section of rod 6

Fixed sets of middle rod 7

Middle section of rod 8

Lower section of rod 9

Bracket 10

Antiskid of top rod 11

Antiskid of upper rod 12

Antiskid of middle rod 13

Antiskid lining of upper rod

Antiskid lining of middle rod

Antiskid lining of lower rod

Brush 17

Al-plate of brush 18

Brush head 19

Top cover of brush 20

Bottom cover of brush

Installation & Operation

1 Take out rod set and against slide hose hanger Install the hanger 2 Cut rod-set in Fixed Sheath of Rodset Screw the knob for fixing rod