Инструкция по эксплуатации JVC WR-MG250 — страница 8

Adjust the angle of the LCD monitor. z The LCD monitor can be tilt upwards to a maximum angle of 30 degrees.

Seal the marine case. z Make sure that the O-ring is not twisted and that you did not forget to attach it.

z Make sure that foreign objects (strap belt dirt etc.) have not been caught in between.

z The risk of water leakage is extremely high if the O-ring is twisted if you forget to attach it or if something is trapped in the seal.

Check that all the operation buttons of the camera are functioning properly. z If it is not functioning take out the camera and insert again.

Attach the grips. z Attach the grips lights or weights on the bottom of the marine case.

Before recording

Submerge the marine case with the camera inserted into a bathtub or water tank full of fresh water Gradually prolong the time the marine case is submerged as follows.

z 1st time: 5 ~ 10 seconds z 2nd time: 30 seconds ~ 1 minute z 3rd time: 3 minutes ~ 5 minutes (try operating the levers and buttons while the marine case is submerged).

z Always have someone hold the marine case for you when diving into or getting out of water to prevent loss or damages.

z If for any reason water leakage occurs remove the camera battery It may cause the camera to explode.

Turn on the camera’s power. z Press and hold the power button for more than 2 seconds to turn on the power (The camera’s power lamp lights and the monitor turns on.)

z Sometimes due to sudden shaking or impact to the marine case the camera’s drop detection function operates to turn off the camera’s power When the camera’s power is turned off turn it on again When “VIDEO MANAGEMENT FILE IS BROKEN TO RECORD/PLAYBACK VIDEO RECOVERY IS REQUIRED. RECOVER?” is displayed press the REC button to recover the file.

Caution 2

Large hexagonal wrench (for screwing the grips)

Recording the Video/Still Image Files

Caution

Note

ON/OFF

WR-MG250_EN.book Page 8 Thursday June 4 2009 11:09 AM