Инструкция по эксплуатации JVC WR-MG250 — страница 7

Setup the camera. z For models equipped with light turn off the light.

z Open the lens cover. z Set to the shooting mode (video/still image).

¹ Even when the shooting mode is set to

“video” still images can be captured by pressing the still image lever during video recording.

z It is recommended to set to the auto shooting mode.

z Insert the battery and micro SD card beforehand if needed.

z To turn off the camera press and hold the power button for more than 2 seconds.

Insert the drying agent at the back of the base.

Attach the base to the bottom of the camera. z Align the tripod screw hole at the bottom of your camera with the screw of the base and tighten the screw.

z The camera turns on automatically when the

LCD monitor is opened To turn off the camera press and hold the power button for more than 2 seconds.

Fold the grip belt. z Make sure the grip belt is not caught between the marine case when sealing.

Open the marine case. z If it is difficult to open buckles use the small hexagonal wrench (buckle opener).

Insert the camera into the marine case. z Align the base attachment groove with the base to insert.

Attaching the Marine Case to the Camera

Caution 1

Pass underneath

Catch

Drying agent

Tighten the screw

Open up the LCD monitor

1 Unlock the grip belt pull the belt out and lock again.

2 Fold the grip belt and pass the front end through the inner side of the belt.

3 Pull the end that has been passed through the inner side of the belt and adjust the length (If the end is pulled out too much it may be recorded into the image or get caught in the O-ring when sealing the marine case.)

Lock

Small hexagonal wrench (Buckle opener)

Base attachment groove

Base

Marine case internal base

WR-MG250_EN.book Page 7 Thursday June 4 2009 11:09 AM