Инструкция по эксплуатации Electrolux EU 6221 U — страница 9

SOMETHING NOT WORKING

If the appliance is not functioning properly check that:

If your appliance is still not working properly after making the above checks contact the nearest service centre.

To obtain fast service it is essential that when you apply for it you specify the model and serial number of your appliance which can be found on the guarantee certificate or on the rating plate located inside the appliance on the bottom left-hand side.

Dérangement

Remède

Appliance does not function no pilot light is illuminated.

The freezer temperature is not sufficient red light lights up.

Large accumulation of frost in the appliance perhaps also at the door seal.

Unusual noises.

The compressor does not start immediately after pressing the fast freeze button or after changing the temperature setting.

Appliance is not switched on; switch appliance on.
Mains plug is not inserted or is loose; insert mains plug.
Fuse has blown or is defective; check fuse replace if necessary.

Mains socket is defective; Mains malfunctions are to be corrected by an electrician.

Temperature is not properly adjusted; please refer to the section “Temperature regulation”.

Door was open for a long time; only leave the door open as long as necessary.

Within the last 24 hours a large quantity of warm foods were loaded; press the fast freeze button.

Appliance is next to a source of warmth; please refer to the section “Location”.

Door is not properly sealed (perhaps after re-hanging door); carefully warm the door seal with a hand-held hair dryer at those points which are not airtight (no warmer than approx 50°C) At the same time shape the warmed door seal by hand so that it is again properly seated.

Appliance is not level; readjust the front levelling feet.
Appliance is in contact with wall or other objects; push appliance away a short distance.

A part at the back of the appliance e.g a tube is in contact with another appliance part or the wall; bend this part away carefully if necessary.

This is normal no error has occurred; the compressor starts after a period of time.

TECHNICAL SPECIFICATIONS

The technical data is indicated in the rating plate on the left side inside the appliance.