Инструкция по эксплуатации Electrolux EU 6221 U — страница 11

Door reversal

The appliance must be unplugged before starting work To reverse the opening direction of the door proceed as follows:

1 Remove the top hinge (1) taking care not to let the door fall.

2 Remove the bottom door hinge (2).

3 Take out the plugs (3) from the holes (F) and reinsert them in the holes (F

) on the opposite side.

4 Refit the upper hinge (1) on the opposite side on the bottom (position A).

5 Refit the door on the pin of the hige (1) in position

6 Insert the pin of the previously removed bottom hinge (2) in the upper hole (G) of the door therefore fix the hinge on the top in position B.

Building in the appliance under a worktop

The dimensions of the recessed installation area must correspond with those indicated in the figure The appliance could be inserted between two units (a) or as an end unit (b).

Important

It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation.

Fasten the side panel to the rear of the appliance with the fixing brackets.

S.I.003

S.I.004

820 870 b a

S.I.005

D326

SUPER.

INFER.

UPPER

LOWER