Инструкция по эксплуатации Electrolux EU 6221 U — страница 10

lf this appliance featuring magnetic door seals is to replace an older appliance having a spring lock (latch) on the door or lid be sure to make that spring lock unusable before you discard the old appliance This will prevent it from becoming a death-trap for a child.

Positioning

The appliance should be installed well away from sources of heat such as radiators boilers direct sunlight etc Best performance is obtained with ambient temperature between +18°C and +43°C (class T);
+18°C and +38°C (class ST); +16°C and +32°C
(class N); +10°C and +32°C (class SN).
The class of your appliance is shown on its rating plate.

For building-in and door reversibility refer to the relevant instructions.

Electrical connection

Before plugging in ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply Voltage can vary by +6% of the rated voltage For operation with different voltages a suitably sized autotransformer must be used.

Important

The appliance must be earthed.

The power supply cable plug is provided with a contact for this purpose If the domestic power supply socket is not earthed connect the appliance to a separate earth in compliance with current regulations consulting a specialist technician.

The Manufacturer declines all responsibility if the above safety precautions are not observed.

This appliance complies with EEC directive number 87 308 of 2/6/87 relative to radio interference suppression.

This appliance complies with the following E.E.C Directives:

73/23 EEC of 19.2.73 (Low Voltage Directive) and subsequent modifications;

89/336 EEC of 3.5.89 (Electromagnetic

Compatibility Directive) and subsequent modifications.

INSTALLATION

Grid preparation

Remove the grid from the appliance pulling it towards you with hands.

Right door opening:

Remove the left side (A) of the grid cutting it from the rear (see figure a).

Left door opening:

Remove the right side (B) of the grid cutting it from the rear (see figure b).

To reposition the grid on the appliance proceed as follows:

Apply the grid to the base of the appliance by pushing the clasps (a) until they click.

N.B The grid is to be assembled after having fixed the appliance in the niche with the brackets.

S.I.002

S.I.001