Инструкция по эксплуатации Electrolux EOB6850AOX — страница 11

Do not put water directly into the steam generator Use only water Do not use filtered (demineralised) or distilled water Do not use other liquids Do not put flammable or alcoholic liquids into the water drawer.

3.Push the water drawer to its initial position.

4.Activate the appliance.

5.Prepare the food in the correct cookware.

6.Select the steam heating function and temperature.

7.If necessary set the function Duration or End Time

The signal sounds at the end of the cooking time.

8.Deactivate the appliance Let the appliance dry fully with the door open.

9.Empty the water tank after the steam cooking is completed.

WARNING!
Wait a minimum of 60 minutes after each use of the steam cooking in order to prevent hot water from exiting the water outlet valve.

5.6 Tank Empty indicator

The display shows Water required and an acoustic signal sounds when the tank is empty and must be refilled For more information refer to "Steam Cooking".

5.7 Tank Full indicator

When the display shows Water tank full you can use the steam cooking An acoustic signal sounds when the tank is full.

If you put too much water into the tank the safety outlet moves the excess water to the bottom of the oven Remove the water with a sponge or cloth.

5.8 Emptying the water tank

Make sure that the appliance is cool before you start to empty the water tank.

1.Prepare the draining pipe (C) included in the same package with the user manual Put the connector (B)
onto one of the ends of the draining pipe.

2.Put the second end of the draining pipe (C) into a container Put it at a lower position than the outlet valve (A).

3.Open the oven door and put the connector (B) into the outlet valve (A).

4.Push the connector again and again when you empty the water tank.

5.Remove the connector from the valve when the water stops flowing.

WARNING!
Do not use the drained water to fill the water tank again.

The tank can have some water when the display shows Water required Wait until the water flow from the water outlet valve stops.

5.9 Heat-up indicator

When you activate a heating function the bar on the display comes on The bar shows that the temperature increases.

5.10 Fast Heat Up indicator

This function decreases the heat-up time To activate the function hold for 3 sec-

B
C

ENGLISH