Инструкция по эксплуатации Binatone Active XA1001 — страница 3

ФорматФормат: Руководство СтраницСтраниц: 37 КатегорияКатегория: Радиотелефоны ДобавилДобавил: OLD

Инструкция для Инструкция по эксплуатации Binatone Active XA1001 на русском языке. Документ можно использовать для ознакомления с информацией, относящейся к данной модели.

Инструкция представлена в формате PDF, просмотр, скачивание на компьютер, смартфон бесплатно. Возможность печати зависит от используемой программы и настроек устройства. Содержание, структура и объём документа могут различаться в зависимости от модели, версии и редакции руководства. Перед использованием рекомендуется убедиться, что инструкция соответствует вашей модели.

Назад
/ 37
Вперёд
Страница 3
ENGLISH

32 Battery compartment cover – to fix the rechargeable battery in its compartment.

33 Handset belt clip –use it if you want to wear the handset on your belt.

34 Belt clip slot – to fix the belt clip on the handset.

Figure D

35 Battery compartment – for installing a 9V battery.
36 Battery compartment cover – to fix the battery in its compartment.

37 Screw – to fix the battery compartment cover in place.
38 P-T switch – to change dialing mode (pulse/tone).

Figure E

39 Base unit AC adapter jack – to connect the AC adapter to the base unit.

40 Telephone line jack – to connect the phone to the telephone line.
41 Base unit AC adapter– to connect the base unit to the 220V

AC mains.

42 Telephone line cord – to connect the phone to the telephone line.

In your package

1.Handset – 1

2.Base unit – 1

3.Phone line cord – 1

4.AC Adapter – 1

5.Rechargeable battery – 1

6.Battery compartment cover – 1

7.Handset belt clip – 1

8.9V battery compartment cover – 1

9.Screw – 1

INSTALLING AND

CONNECTING

1 Insert the rechargeable battery [30] into the battery compartment

[31] on the handset [1] then close the battery compartment with the cover [42] (see Fig C).

2 Insert a 9V battery (6F22 type) into the battery compartment [35]

on the base unit [28] then close the compartment [35] with the cover [36] and fasten the cover [36] with the screw [37] (see Fig D).

3 Connect one end of the phone line cord [42] to the phone line jack

[40] at the base unit [28] rear side and the other end of the phone line cord [42] to the phone line socket.

4 Insert the AC adapter [41] cable plug into its jack [39] at the base unit [28] rear side Insert the AC adapter [41] plug into a wall outlet of your 220V electric mains (see Fig E).

5 Place the handset [1] on the base unit [28] (see Fig B) Before initial use you should fully charge the battery for about 15 hours When you place the handset [1] on the base unit [29] for charging you should hear a short beep.
Нашли ошибку?