Инструкция по эксплуатации ZELMER GE1000 — страница 28

GW40-007_v01

Suggestion

Information on the product and suggestions for its use

The appliance is intended for household use indoors

only.

The heating surface is coated with special non-stick

layer; therefore do not use sharp utensils for turning grilled products Use only soft wooden spatula.

In order to provide additional protection it is

recommended to install the residual current device (RCD) with nominal residual power not exceeding 30 mA You should contact the professional electrician in this concern.

While cooking some fatty dishes it can be necessary

to empty the grease drip tray.

The appliance is intended solely for household use

indoors.

Apply the recommended temperature setting You can

adjust the temperature during grilling if necessary.

Assemble the heating plate (3) at the base.

Apply a small amount of oil on the heating plate before usage and distribute it with paper towel.

If necessary assemble the glass cover (6) In order to do it insert the protrusions of the glass cover in the opening of the grill base.

After assembling the cover is in open position

Before you close it lift it up.

Usage of the glass cover is recommended in

particular when grilling products containing fat.

Insert the thermostat with supplying cord (7) in the appliance socket Make sure that the thermostat knob is in

“0” position.

Connect the supplying cord to the mains supply outlet.

Start-up

Set the thermostat

(7) for desired temperature (”1” to “5”).

“1” = the lowest temperature.

“5” = the highest temperature During warming up the pilot light (8) glows When the appliance reaches the set temperature the light goes off and the heater shall switch off The grill heat up from time to time in order to keep the set temperature.

During first usage the preserving materials

shall be burnt which can cause short emission

of unpleasant smell at the initial stage of

grilling.

It is not allowed to move the hot appliance

during operation! At first switch off and wait

until it cools down Move with heat�resistant

handles only.

Operation guidelines

It is recommended to wipe the surface with edible oil

before grilling products in order to improve the nonsticking properties.

The grids

(4) are perfect for preparing meat fish and poultry The fat and juice flows though the grids spaces down to the grease drip tray which provides preparation of healthy and low-fat meals.

The grilling plate

(5) is perfect for preparing eggs ham tomatoes onion etc It is also excellent for keeping the dishes warm.

The 3–4 level is recommended In order to obtain uniform

grilling.

Heat the grids before putting the products on.

When preparing tender dishes (i.e fish) after applying

spices you can wrap it with aluminium foil.

Soft pieces of meat are the best for grilling.

Outline (Fig A)

Grill base

Grease drip tray

Heating plate

Grids

Grilling plate

Glass cover

Thermostat with supplying cord

Pilot lamp

Heat-resistant handles

Specifications

The appliance is built in I class isolation grounding necessary.

Technical parameters are included at the name plate.

Grill meets the requirements of appropriate standards.

The appliance meets the requirements of the following directives:

Low Voltage Device (LVD) – 2006/95/EC.

Electro Magnetic Compatibility (EMC) – 2004/108/EC.

The product is marked with CE symbol on the name plate

Assembling (Fig B)

Remove all stickers before first usage and

clean the appliance thoroughly (see: „Cleaning

and maintenance”).

Make sure hat the heating plate socket and thermostat

plug are dry.

Install the grease drip tray (2) at the base (1) Always put aluminium foil inside the grease drip tray to make cleaning easier.