Инструкция по эксплуатации Yamaha RX-V663 — страница 18

Connections

■ Connecting the speaker cable

Remove approximately 10 mm (0.4 in) of insulation from the end of each speaker cable and then twist the exposed wires of the cable together to prevent short circuits.

Loosen the knob.

Insert one bare wire into the hole on the side of each terminal.

Tighten the knob to secure the wire.

■ Using bi-amplification connections

This unit allows you to make bi-amplification connections to one speaker system Check if your speakers support biamplification To make the bi-amplification connections use the FRONT and SURROUND BACK/BI-AMP terminals as shown below To activate the bi-amplification connections set “BI-AMP” to “ON” in “ADVANCED SETUP” (see page 109).

When you make the conventional connection make sure that the shorting bars are put into the terminals appropriately Refer to the instruction manuals of the speakers for details.

10 mm (0.4 in)

Red: positive (+)

Black: negative (–)

Caution Remove the shorting bars or bridges of your speakers to separate the LPF (low pass filter) and HPF (high pass filter) crossovers.

Note

FRONT A

SURROUND BACK/

BI-AMP

SINGLE

This unit

Left

Right

Front speakers