Инструкция по эксплуатации Yamaha RX-V365 — страница 13

Connections

* You can select the front speaker set from Front speakers (A) and Front speakers (B) by pressing CSPEAKERS repeatedly See page 19 for details.

■ Connect speaker cables to each speaker

Cables are colored or shaped differently perhaps with a stripe groove or ridge Connect the striped (grooved etc.)
cable to the “+” (red) terminals of your speaker Connect the plain cable to the “–” (black) terminals.

■ Before connecting to the SPEAKERS terminal

A speaker cord is actually a pair of insulated cables running side by side

Remove approximately 10 mm (3/8”) of insulation from the end of each speaker cable and then twist the bare wires of the cable together to prevent short circuits.

■ Connecting to the FRONT A terminals

Loosen the knob.

Insert the bare end of the speaker wire into the slit on the terminal.

Tighten the knob to secure the wire.

■ Connecting to the FRONT B CENTER and

SURROUND terminals

Press down the tab.

Insert the bare end of the speaker wire into the hole on the terminal.

Release the tab to secure the wire.

Speakers

Jacks on this unit a Front speaker (A) Right*

FRONT A (R)

b Front speaker (A) Left*

FRONT A (L)

c Surround speaker Right

SURROUND (R)

d Surround speaker Left

SURROUND (L)

e Center speaker

CENTER

f Front speaker (B) Right*

FRONT B (R)

g Front speaker (B) Left*

FRONT B (L)

h Subwoofer

SUBWOOFER

10 mm (3/8”)

Red: positive (+)

Black: negative (–)

Red: positive (+)

Black: negative (–)