Инструкция по эксплуатации WORX Tools WU601.1 — страница 12

Router ENG

value and actual value).

Retighten wing screw again.

Slide router upward again and check depth-ofcut by carrying out another trial cut.

After setting the depth-of-cut the position of the index mark (26) on the depth stop should not be changed anymore so that the currently adjusted setting can always be read off the scale.

5 USAGE OF THE STEP BUFFER

a) Dividing the cutting procedure in several steps

For deep cuts it is recommended to carry out several cuts each with less material removal

By using the step buffer the cutting process can be divided into several steps.

Set the required depth-of-cut with the lowest step of the step buffer Afterwards the higher steps can be used for the last two cuts.

b) Pre-adjustment of varying depth-ofcuts

If several different depth-of-cuts are required for the machining of a work-piece these can also be preset by using the step buffer.

6 DIRECTION OF FEED (See a b)

The feed motion of the router must always be carried out against the rotation direction of the router bit (up-grinding)

When milling in the direction with the rotation of the router bit (down cutting) the router can break loose preventing control by the user.

7 ROUTING PROCESS

Adjust the depth-of-cut as previously described

Place the router on the work-piece.

Release the clamping lever by turning in clockwise direction and slowly lower the router until the depth stop runs against the step buffer Lock the router in position by turning the clamping lever in anti-clockwise direction then switch on Carry out the cutting procedure with uniform feed After finishing the cutting process slide the router upwards again and switch off.

8 ROUTING WITH GUIDE BUSHING

The guide bushing (24) enables template and pattern routing on work-pieces.

Place the guide bushing over the hole in the center of the base plate and align the two through holes in the bottom of the base plate with the countersunk holes in the guide bushing Fasten the guide bushing with the nuts and screws provided.(See D).

9.ROUTING PROCESS (See E)

Choose a router bit with a smaller diameter than the inner diameter of the guide bushing.

Set the router with guide bushing against the template Release the clamping lever by turning in clockwise direction and slowly lower the router toward the work-piece until the adjusted depth-of-cut is reached.

Guide router with projecting guide bushing along the template applying light sideward pressure.

Note: The template must have a minimum thickness of 8 mm due to the projecting height of the guide bushing.

10.SHAPING OR MOLDING

APPLICATIONS

For shaping or molding applications without the use of a parallel guide the router must be equipped with a pilot or a ball bearing.

Lead the router sideward to the workpiece and allow router bit to engage until the pilot or the ball bearing of the router reach the corner of the workpiece being machined Guide the router alongside the workpiece corner using both hands ensuring proper seating of the base plate Too much pressure can damage the edge of the workpiece.

11.ROUTING WITH PARALLEL GUIDE

(Accessory – See F,G)

- Slide the parallel guide (21) with the guide rods(27) into the base plate (10) and tighten at the required measure with the wing bolts (12).

- Guide the machine with uniform feed and sideward pressure on the parallel guide (21) along the edge of the workpiece.

12.ROUTING CIRCULAR ARC PROFILES

(See H I)

To reassemble the router guide for use as a circle guide (arc guide) follow below steps:

• Loosen rear wing knobs (28) and fine adjustment knob(A) spacer and indicator (B) remove these parts from guide rods (C).

• Loosen front knobs and guide base (E) remove from the guide rods.

• Remove springs (D) from guide rods.

• Reinstall fine adjustment guide (F) onto guide rods rotate 180 degrees from normal position so that circle guide hole faces away from the

UKR-WU600 WU600.1 WU601 WU601.1-M-060726.indd 12

2006-7-26 14:08:54