Инструкция по эксплуатации ViTESSE VS-330 — страница 4

ASSEMBLY AND USE 5 The Round Brush and the Curved Nozzle Accessory can be attached to end of the Jet

Nozzle by pushing the accessory on using the hexagonal alignment as a guide.

Nylon Round Brush Round Brush recommended for cook tops and bench tops.

Angled Nozzle Curved Nozzle recommended for hard reaching area such as window sills and toilet

To use the Window Cleaning attachment It must be clipped Into the Fabric Accessory by hooking the two hinges onto the tabs and lifting the window cleaner around to the top of the fabric tool and clipping the latch onto the fabric cleaner to secure In place To remove the window cleaner simply lift the latch to uncllp and separate WARNING: Using window cieaner on cold glass may cause the glass to break Proceed with caution when carrying out this operation To use the Fabric Accessory stretch the Cloth Covering to fit over the Fabric Accessory It Is recommended that the Fabric Accessory be attached to the flexible hose for maximum accessibility for clothing upholstery and window furnishings.

STARTING THE STEAM CLEANER 8 PlugthepowercordIntoanelectrIcaloutlet.ResIstanceIndIcatorllghtgoeson. 9 After 3-4 minutes the appliance Is ready to generate the steam.

WARNING: Do not leave the steam cleaner unattended while waiting for steam.

10 Press the Steam Lever to emit the steam and begin passing slowly over the surfaces

Intended for cleaning For disinfecting areas hold the steam cleaner no more than 1 Inch away from the surface and pass over slowly until entire area Is covered.

FURTHERWATERTANK FILLING 11 Unplug the power cord from electrical outlet. 12 Press and hold Steam Lever until all pressure has been released. 13 Before opening Water Tank Cap It Is Importantto wait approximately 3 minutes for the

appliance to cool down Slowly turn the cap only a half turn and wait for the hissing sound (If any) to completely stop The hissing sound may be present due to residual pressure not released while holding the steam lever.

14 Carefully press the cap and unscrew It and follow process outlined In step 1 and 2.

MAINTENANCE NOTE: Please ensure the steam cleaner has been unplugged from the power source and cooled down before any cleaning and maintenance Is carried out. 15 Always empty any excess water from water tank after each use This operation will prolong the life of your appliance.

16 Always ensure the unit has cooled before putting it away in a dry cool place. 17 To ensure the highest level of operation over a long period of time It Is recommended that the water tank be rinsed out with water at least once a month to clean any water calcification accumulated Do not use vinegar or other substances to remove lime scale deposits.

18 To clean fill with one measure of water replace cap and shake unit to loosen any lime scale deposits Remove cap and empty waterfrom tank.

WARNING: Do not Immerse the steam cleaner In water.

TECHNICAL SPECIFICATIONS Voltage: 220-240 V-50 Hz Power: 1200 Watt

TROUBLE

PROBLEM

Unit will not srt'iTh on.

Unil

Djl ïHïiter frmn nozzle.

SHOOTING GUIDE

POSSIBLE SOLUTION

EiBure the powe cord has seen plugged 1п’л s power bocliel and Cts cjtlsl is s'^tch ON. Chenk Ihs л'яге'lank islili'id cn fneerly Try anclhsr power oudet Level in water tar^k may be teo hign Check wrater tank and do ao: oveftill так 4QC-ml Hold In upr^ht positlan Do not tjm ;he steame' nn hs side Unit not to iy heated Allow the unit time 1c heat the water

Accessc'ies once attached do net stay on.

Unit is not pnoduc np steam.

Check that enough foiice has been applied to ensure tne aocessories sne sfl