Инструкция по эксплуатации Vitek VT-6403 BK — страница 7

English

Switching data receipt channels Press the CHANNEL button to switch data receipt channels from remote sensors (Ch 1 Ch Ch ) indoor (IN) switching on cycle displaying of temperature data from different channels (

Temperature change tendencies Temperature change tendencies are displayed as arrows (growing constant falling down) near the corresponding data.

Viewing minimal/maximal temperature value At each press the MEM button the switching between displaying of the following parameters appears:

Current temperature

• Minimal temperature

• Maximal temperature

Reset of the minimal/maximal temperature values Press and hold the MEM button for more than seconds to clear memory of all the channels

Note: during operation of the remote sensor at temperature below 0°C voltage in the batteries can drop thus reducing the effective radius of its emitter.

SETTING THE DATE AND THE CURRENT TIME The base unit can display current time and the date To switch between the current time date and day press the CLOCK button To set the current time and the date press and hold the CLOCK button for more than seconds You can select time displaying format (1 hours or 4 hours) set the current time (hours: minutes) and the date Use the

▼/▲” to enter the parameters To confirm the entered parameters press the

CLOCK button.

SETTING ALARM ACTUATION TIME To switch on the alarm mode press the ALARM button The “AL” symbol will appear on the LCD-display To switch on/off the alarm press the button once again when the alarm is on the symbol will appear on the LCD-display.

To set the alarm actuation time press and hold the ALARM button Digits of hours will start flashing.

Use the “

▼/▲” buttons to set the actuation hour To confirm the setting press the ALARM button

Digits of minutes will start flashing.

6403IM.indd 7

19.03.2008 14:13:46