Инструкция по эксплуатации Vitek VT-6403 BK — страница 4

English

Remote temperature sensor (Pic 2)

1 LED-indicator

Battery compartment lid (

for batteries of “ААA” type)

Sensor re-boot button after changing channel number Тх 4 Switching button between Celsius and Fahrenheit scales C/F 5 Channel switch (1--)
6 Hole for fastening units on the wall

PRECAUTIONS 1 Before operating the units read the instruction carefully. Do not immerse the units into water. Do not use abrasives or substances causing damages of the body and inner parts to clean the units 4 Do not expose the units to strong physical stress do not subjects the units to strikes (dust and moisture are also contraindicated

) as it can lead to failures and correspondingly to the reduction of life time damages of the batteries and to the deformation of the body details.

5 Do not dismantle the unit; it will lead to the termination of the guarantee

There are no parts requiring attention of the user inside it 6 Use only new and specified in the manual batteries Do not use old and new batteries together.

7 Use the net adapter supplied

BEFORE OPERATION Set the remote sensor within effective data transfer radius and as close as possible to the base unit Place the base unit and the remote sensor in places with minimal interferences for better data transfer.

Take into consideration that the data transfer radius depends on the construction material of the partitions of the building and its quantity Try out several variants of the remote sensor and base unit placement In spite of the fact that the remote sensor is protected from meteorological conditions it should be set away from direct sunlight rain or snow House mechanisms (door bell signal system etc.) can cause interferences for the reception of data signals from the remote sensor by the base unit It is normal and does not influence the general operation Transfer and reception of the data signal will resume immediately after the temporary interferences disappear

Placing batteries in the remote sensor 1 Unscrew the screws on the battery compartment lid. Select data transfer channel using the channel switch “1--”. Set batteries (“ААА” 1.5 V) following the polarity. 4 Close the battery compartment lid and tighten up the screws.

6403IM.indd 4

19.03.2008 14:13:46