Инструкция по эксплуатации Vitek VT-6402 BK — страница 8

English

Temperature indications Basic block is able receiving data from tree remote sensors each of them has each own channel for temperature data transmission Centigrade or Fahrenheit degree can be selected as temperature units Use C/F to select temperature units.

Switching between data receiving channels Press button CHANNEL to switch between remote sensors’ data receiving channels (Ch 1 Ch Ch ) indoors (IN) switching between different channels’
temperature data indication (

) in cycle.

Temperature trends Temperature trends are displayed by arrows (increasing decreasing) near the adequate data.

Viewing minimal/maximal value of temperature Each pressing on button MEMORY switches between the next parameters’ indication:

Current temperature

Minimal temperature

Maximal temperature

Minimal/maximal temperature values reset Press and hold button MEMORY for seconds to clear all channels’ memories.

Notice: Remote sensor batteries voltage may decrease while operating at temperature below 0°C thus remote sensor range of action would be shortened too.

Setting date and current time Basic block is able viewing current time and date Press button CLOCK to switch between current time date and day of week.

Press and hold button

CLOCK for seconds to set current time and date You

can choose time indication format (1 hours or hours) and date format (day/
month or month/day) set current time (hours minutes) and date Use buttons

▼/▲» to input parameters Press button

CLOCK for confirmation.

Setting alarm Press button

ALARM to switch on alarm mode Symbol «AL» appears on LCD

Press this button once more to switch alarm ON/OFF when alarm is on symbol

is on LCD.

6402IM.indd 8

11.04.2008 16:37:16