Инструкция по эксплуатации Vitek VT-6402 BK — страница 6

English

Installation of batteries into remote sensor 1 Turn off the screws on the batteries compartment. Select data transfer channel by channels switcher «1--». Install batteries (“ААА” 1.5 V) following polarity. Close battery compartment cover and turn up the screws.

Connecting AC-power adapter to basic block Installation of batteries into basic block

Connect AC-power adapter (,5V;

) to basic block

through the jack for an external power source located below the batteries compartment.

or Open the cover of batteries compartment. Install three batteries (“AАА” 1.5 V) following polarity. Close battery compartment cover.

Note:
Basic block is intended for power supply from external source batteries are used as reserve power source Continuous LCD backlight and continuous projection of time is possible only in case of connection to external power source through AC adapter

Replacing Batteries On appearance of adequate icon indications displaying that the batteries are down replace remote sensor batteries.

Get Started By first startup switch main block on and switch on remote sensor Set data transfer channel by channel switcher «1--» located on remote sensor Hold button CHANNEL on main block you will hear sound signal Main block starts searching remote sensor signal Press button Тх to reset the sensor When connection between sensor and main block is set on temperature indications from remote sensor will appear on LCD.

Setting pressure parameters by switching on the unit first time 1 After connecting basic block to power supply line pressure units’ icon starts

blinking Use buttons

▼/▲»to select pressure units

inHg hPa mBar or

mmHg.

Press button PRESSURE for confirmation.

Use buttons

▼/▲» to set the value of altitude above sea level Press

button PRESSURE for confirmation.

Setting pressure parameters via first startup is imperative for precise weather forecast.

6402IM.indd 6

11.04.2008 16:37:16