Инструкция по эксплуатации Vitek VT-5016 BK — страница 6

ENGLISH

Auto search Using buttons VOL+ VOL you can start automatic search beginning from channel 0 range by range MW- MW-2 (meter waves) DMW (decimeter waves) After the channel with sufficient level of signal has been found search is stopped and cannel is memorized

In order to get sharp picture it is recommended to do the following:
Select screen menu you need. 2 Set corresponding color and sound systems. Perform auto search.

Notice:
In order to provide the best receive try several variants of telescopic antenna placement Low quality picture presence of noise is not the sign of TV-set malfunction In case of weak signal while using telescopic antenna try to connect external antenna by using proper adapter.

Trouble shouting In case of malfunction check the following causes in the table below before turning to the service center.

Problem

Possible cause

There is no picture or sound

• Check if AC or car adapter is connected correctly Use only adapters included into delivery set.

- Check if TV-set is not in standby mode.

There is no picture

• Check if the channel is selected correctly Perform channel auto search For each new place the channel tuning is required

There is no sound

• Make sure the volume level is not minimal.

- Make sure the volume is not switched off.

- Make sure the head phones are disconnected.

Picture is too dark

• Check “Brightness” and “Contract” settings.

Fuzzy picture

• Make sure the antenna is connected properly.

- Weak signal.

There is no picture or sound only noise

• Make sure the antenna is connected properly.

- Weak signal.

Noise of “snowing”
type

• Placement near motor road railway or high-voltage line neon lights etc.

- Interference caused by proximity between the antenna cable and the power supply cable Install these cables at a distance from each other.

Remote Control is not working

• Check batteries in remote control; replace them if necessery.

Monochrome picture fuzzy picture

• Make sure that the picture settings are correct and the color system is chosen properly.

- Weak signal.

- Bad quality of the program.

- Make sure the antenna is connected properly.

Upturned picture

Check “Picture mirror” and “Picture up and down” settings.

5016IM.indd 6

21.02.2008 11:25:59