Инструкция по эксплуатации Vitek VT-4119 SR — страница 8

ENGLISH

System setup 1 Switch TV-set on and select the adequate type of input signal in TV-

set settings.

Press SETUP button to enter system setup menu Press SETUP button again to exit menu.

Use navigation buttons (

←→) to select on of the next pages: main setup page audio setup page video setup page custom setup page password setup page.

Press button (

↓) to enter selected page.

4 Use buttons (

↓↑) to select an item you want to change.

5 Press button

► or → to enter sub-item to change a setting Use navigation buttons (

↓↑) to select required value ► or ← to confirm selected value and return to list of settings.

Attention: some menu items corresponding to preset modes are marked and cannot be selected Input settings are stored even after switching off power.

Main setup page

TV screen 4:/PS: When DVD player is connected to normal TV-set wide screen picture is viewed on the whole screen but its side parts are cut (4:). 4:/LB: When DVD player is connected to normal TV-set wide screen picture is viewed thus there are black regions in upper and down part of the screen (4:). Wide screen: use this item if home theater is connected to wide screen TV-set (16:9). View angle Some DVD movie could be shot from different angles Detailed information concerning this subject you can get from annotation to your DVD disk If this mode is on while playing back DVD disk shot from different angles symbol of camera is displayed on the screen Menu language Selecting on-screen menu language Subtitles This function is not working if there are no subtitles recorded on a disk If disk’s subtitle function if switched off press SUBTITLE button on remote control to switch it on Default setting is ON. Screensaver If screensaver function is on player is switched on but disk is not playing back for several minutes a moving picture is appeared on the screen after 0 minutes player is switched to standby mode You can press button STANBY on remote control to exit standby mode Last memory If this function is on layer remembers the time of disk’s taking out the next time you load the same disk player will play it from the place of last stop and extraction of the disk.

Audio setup page

• Setup speakers

Downmix Left/Right: original sound in 5.1 CH format is transferred through left and right channel only Stereo: original sound in 5.1 CH format is transferred in stereo mode. D surround: effect of D surround sound is created using two channels only. 5.1 CH: original sound in 5.1 CH format is transferred through 5 channels: front central rear speakers subwoofer If your sound system includes front central rear speakers and subwoofer you can set menu items according to real configuration This function would not work if fading function is on (left/right stereo d surround).

Test signal In 5.1CH audio mode select ON (switch test signal on) test signal will be played through all six channel in sequence Setting the system up by test signal is to be done on condition there is no disk in the tray and parameter FADE is set to “5.1СН” position Use this function to examine all audio channels if you are in doubt about the quality of sound.

Dynamic compression (POST DRC)
Dynamic range compression allows decreasing sudden volume jumps caused by sound effects You can switch compression on (ON) or off (OFF) or select automatic mode (AUTO). Post DRC is inactive? when downmix is set 5.1.

• Digital output setup page

Digital output Switch off SPDIF: sound is supplied to appliance output in analog form (5.1 CH AUDIO OUT). SPDIF/RAW: digital output signal in original format as recorded on disk SPDIF/PCM: digital output signal in decoded РСМ format. LPCM output Select setting for audio format: 48 К 96 К.

4119IM.indd 8

20.02.2008 15:16:03