Инструкция по эксплуатации Vitek VT-4024 — страница 11

ФорматФормат: Руководство СтраницСтраниц: 19 КатегорияКатегория: Акустика ДобавилДобавил: OLD

Инструкция для Инструкция по эксплуатации Vitek VT-4024 на русском языке. Документ можно использовать для ознакомления с информацией, относящейся к данной модели.

Инструкция представлена в формате PDF, просмотр, скачивание на компьютер, смартфон бесплатно. Возможность печати зависит от используемой программы и настроек устройства. Содержание, структура и объём документа могут различаться в зависимости от модели, версии и редакции руководства. Перед использованием рекомендуется убедиться, что инструкция соответствует вашей модели.

Назад
/ 19
Вперёд
Страница 11
TROUBLE SHOOTING

If the system do not operate correctly please do the following check up

Some DVD device has high level signal output when the Master Volume is at the maximum the distortion occurs if this happens turn down the volume if the speaker continues in the distortion the speaker unit and amplifier will be damaged.

SPECIFICATION

OUTPUT POWER SUBWOOFER

60 W

FRONT AND REAR

20 W x4

CENTER

20 W

MAXIMUM OUTPUT POWER

160 W

SPEAKER UNIT WOOFER

6-1/2

FRONT

3 (Full Range)

REAR

3 (Full Range)

CENTER

3 (Full Range)

DIMENSION SUBWOOFER

6-1/2 6,5” (16,5 cm)

FRONT

3” (Full Range) (7,6 cm)

CENTER

2x3“ (Full Range) (2x7,6 cm)

ACCESSORIES AAA BATTERIES

2 PCS

SPEAKER CABLES

3 PCS 2 m (CENTER&FRONT)
2 PCS 6 m (REAR)

IN ORDER TO DELIVER THE BEST QUALITY THE SPECIFICATION OF THE SPEAKER MIGHT CHANGE WITHOUT SUBJECT OF NOTICE

SERVICE LIFE OF THE UNIT NOT LESS 7 YEARS

ENGLISH

ISSUE

CAUSED BY

SOLUTION

No Sound from Speaker

No sound from speaker when chose DVD/5.1 output mode

Distortion occurred when in high volume

1 System does not connected with power. 2 The speaker cables are not connected with the output connector 3 The power does not switch ON.

The output setting of the DVD might set to dts decode mode

The sound device has nigh level signal output

1 Check with the power plug 2 Check the speaker cables 3 Make sure the power is ON

Reset the output setting to 5.1 CH output only

Turn down the master volume of the system

4024.qxd 27.08.2004 16:39 Page 10
Нашли ошибку?