Инструкция по эксплуатации Vitek VT-3966 B — страница 9

ENGLISH

press the REPEAT/MONO-ST button to improve sound quality to switch on to the MONO mode.

ANTENNA For the best FM reception completely extend the FM ANTENNA (2 pic.) The device has a built-in antenna in order to receive AM signals Turn the device left or right in order to achieve the best signal reception.

PROGRAMMING RADIO STATIONS You can tune and store 20 stations in each band FM and MW (AM). Select the band and tune to the station which you want to program 2 Press the MEMORY/CLK-ADJ button The

“MEMORY” indication and the “00” station indication will be flashing on the LCD display for 3 seconds.

3 Use the PRESET/FOLDER

or buttons to select the station number from to 20 under which you want to store the radio station.

Press the MEMORY/CLK-ADJ button again to store the settings.

5 Repeat steps – for all radio stations which you want to store in memory

Note: you must select the station number while the MEMORY indication is flashing otherwise the station will not be stored in the memory If the indication disappears before you select the number of the station repeat steps -.

PROGRAMMED RADIO STATIONS RECALL To recall the programmed radio stations select the corresponding frequency band (FM or MW

(AW)) and press the PRESET/FOLDER

or buttons successively to select the desired radio station Note: The preset stations are stored in memory while the device is plugged in and the battery is not low When the power is off or the battery is low the preset radio stations will be erased from memory You will need to program them again.

CD PLAYBACK Loading – open the CD compartment lid Insert a CD disc and close the CD compartment lid Ejecting – after the playback stops open the CD compartment lid and eject the disc Put the disc in the case for storage Always close the CD compartment lid in order to prevent it from getting dust Always eject a disc from the CD compartment if it is not being played back. Switch on the cassette recorder by pressing the POWER button.

2 Select the CD playback mode To select it press the FUNCTION button successively until the “CD” indication appears on the LCD display.

3 Open the CD compartment Insert a CD disc and close the CD compartment Number of tracks and total playback time will appear on the LCD display.

If after a CD disc have been inserted the “NO DISC” indication appears on the LCD display check whether the disc is inserted properly The disc should be inserted with the label up. To playback the disc from the first track press the PLAY/PAUSE button You can select a track which will be played back first To do it select a track using the SKIP TUNING  or  buttons then press the PLAY/PAUSE button.

5 To pause the playback press the PLAY/

PAUSE button again The “PLAY” indication and the playback time will be constantly flashing To resume to playback mode press the button once again.

6 To stop the playback press the STOP button.

Note: if the CD compartment lid is open the

“OPEN” indication will appear on the LCD display.

PROGRAMMED PLAYBACK You can program playback of tracks (max 60 tracks) in a desired sequence. Switch on the cassette recorder by pressing 3966IM.indd 9

07.07.2008 15:40:50