Инструкция по эксплуатации Vitek VT-3951 B — страница 5

ENGLISH

Remote control 27 The PROGRAM button 28 The track/folder button: 0/FOL +0/FOL+
29 The PLAY/PAUSE (

►║) USB button

0 The BACK track button fast rewind /
The NEXT track button/fast forward /
2 The STOP button The REPEAT/RANDOM button Volume control (is inactive in the radio mode and cassette playback mode)

Before operating Unpack the unit Remove the stickers from the upper and front panel Attention! Do not remove the stickers concerning safety on the rear panel!
Press the CLOSE/OPEN button and remove the protective insert before operating the unit.

POWER CONNECTION Line supply Before connecting the unit make sure that your home electricity supply corresponds to the voltage specified on the unit. To connect the unit insert the plug of the power cord in the corresponding jack (2). Set the switch () in the desired operating mode.

Note: Static electricity can lead to interferences in the operation of the unit In this case disconnect the unit and then connect again If the problem does not disappear apply to a service center.

2 To switch off the unit completely disconnect the power cord from the power supply

Note: Static electricity can lead to interferences in the operation of the unit In this case disconnect the unit and then connect again If the problem does not disappear apply to a service center.

Battery supply Disconnect the cassette recorder. 2 Open the main battery compartment lid () on the rear of the unit by pressing the catch.

Insert 8 UM-2/R C batteries (not supplied) in the battery compartment following the polarity

Close the battery compartment lid ().

USING THE REMOTE CONTROL Insert 2 АAA batteries (not supplied) in the battery compartment of the remote control When using the remote control direct it to the infrared SENSOR on the cassette recorder The effective distance of the remote control operation is about 5 meters in case of its operating distance reduction check the batteries and replace them if necessary.

The functions of the buttons on the remote control are the same as those of the buttons on the cassette recorder Do not expose the remote control to high temperature or direct sunlight; it can negatively affect the operation of the unit.

Attention!
Battery leakage can lead to injuries and damages of the unit To avoid it follow the instructions below:
Place the batteries properly following the polarity marked inside the unit.

Do not use old and new batteries or batteries of different types together.

Take the batteries out if you are not going to use the unit for a long time.

BASIC FUNCTIONS Select operating mode using the switch ():

AUX (MP) TAPE (OFF) RADIO.

2 Use the volume knob to set the desired volume level ().

After using the unit set the switch to OFF position.

Attention! In order to save energy always set the operating mode switch to OFF position when you are not using the unit.

Radio stations reception Set the operating mode switch to RADIO position 2 Select the desired range: FM AM or FM ST

(FM stereo) by setting the range switch to the corresponding position.

While tuning to a station transferring stereo signal the FM ST indication will light up.

Rotate the TUNING knob to select the desired radio station

For better reception in FM band extend the aerial completely and place it at the desired angle For reception in AM band the cassette recorder has a built-in antenna 3951IM.indd 5

19.05.2008 15:20:30