Инструкция по эксплуатации Vitek VT-3951 B — страница 4

ENGLISH

the unit Technical maintenance must be performed only by qualified service personnel

Install the unit in places with proper ventilation.

The product should be situated away from heat sources such as radiators heaters stoves or other products (including amplifiers) that produce heat Do not expose the unit to direct sunlight excessive dust or mechanical shocks

Be especially careful if children or disabled people are near the operating appliance Do not leave them unattended

Make sure that no foreign objects get into the openings of the unit; it can lead to fire or electric shock If it happens unplug the unit and apply to a service centre

Conditions Requiring Service Unplug this unit from the wall outlet and refer to qualified service personnel under the following conditions:
a) When the power supply cord or plug is damaged.

b) There are foreign objects inside the unit. c) If the unit has been exposed to rain or water. d) If the unit does not operate normally. e) If the unit has been dropped or has been damaged in some other way.

f) When the unit exhibits a distinct change in performance-this indicates a need for service.

Cleaning the unit Disconnect the unit from wall outlet before cleaning Use damp soft cloth to clean the unit Front panel could be wiped by soft cloth damped with soap solution It is forbidden to use liquid or aerosol-like cleansers.

Cleaning disks Do not use cracked or deformed disk doing so would cause damage of the unit Hold disk by its edges only Do not touch its operating surface Dust scratches and finger prints on disk operating surface could cause its eternal damage Do not expose your disks to direct sun light heat radiation high temperature and humidity Put disk into case for storage after use Periodically wipe operating surface of disk with soft cloth periodically from center to edges Do not use common cleansers.

IDESCRIPTION Volume knob – VOL+
2 The AUX IN jack for connection of the external device (set the operating mode switch to MP/AUX position Connect the MP player Note: You should first eject a disc from the disc slot.)

The PHONES jack The operating mode switch (AUX (MP)

TAPE (OFF) RADIO)

5 Cassette deck control buttons:

The RECORD (

●) button; the PLAY (

◄) button; the F REW (

►►) button; the F FWD (

◄◄) button; the STOP EJECT (

■▲) button; the PAUSE (

║) button.

6 The OPEN/CLOSE button 7 The band switch (FM ST FM AM)
8 The USB-jack 9 FM – aerial 0 The TUNING knob The battery compartment lid 2 The PLAY/PAUSE/USB button (press and hold this button for more than ,5 seconds to change a media device CD/
USB)

The STOP button The BASS button 5 The FM ST indication 6 The BASS indication 7 Cassette compartment 8 LCD-display (displays FM AM frequency and the current state of the unit)

9 IR-sensor 20 The PROG button for programming and viewing the programmed tracks

2 The BACK button – return to the previous track (press and hold this button for more than 5 seconds to fast rewind)

22 The NEXT button – move to the next track (press and hold this button for more than 5 seconds to fast forward)

2 The REP/RAN (repeat/random playback)button 2 Power supply jack 25 Handle for carrying 26 Speaker

ENGLISH

3951IM.indd 4

19.05.2008 15:20:30